Using electric current to surpass the microstructure breakup limit
نویسنده
چکیده
The elongated droplets and grains can break up into smaller ones. This process is driven by the interfacial free energy minimization, which gives rise to a breakup limit. We demonstrated in this work that the breakup limit can be overpassed drastically by using electric current to interfere. Electric current free energy is dependent on the microstructure configuration. The breakup causes the electric current free energy to reduce in some cases. This compensates the increment of interfacial free energy during breaking up and enables the processing to achieve finer microstructure. With engineering practical electric current parameters, our calculation revealed a significant increment of the obtainable number of particles, showing electric current a powerful microstructure refinement technology. The calculation is validated by our experiments on the breakup of Fe3C-plates in Fe matrix. Furthermore, there is a parameter range that electric current can drive spherical particles to split into smaller ones.
منابع مشابه
EFFECT OF CURRENT DENSITY ON MICROSTRUCTURE AND CORROSION BEHAVIOR OF PURE COBALT COATINGS OBTAINED
Pure cobalt coatings were electrodeposited on copper substrate by means of direct electric current in a chloride solution at different current densities in the range of 10-70 mA cm -2 . The surface morphology and microstructure were investigated via X-ray diffraction analysis and scanning electron microscopy. Corrosion behavior of cobalt coatings was also studied in a 3.5 wt% NaCl soluti...
متن کاملEffects of Statically Electric Fields on Freezing Parameters and Microstructures of Button Mushrooms (Agaricus bisporus)
Background and Objectives: Freezing under statically electric fields is one of the novel freezing methods to improve the quality of frozen products by controlling the nucleation process. The objective of this study was to investigate effects of freezing under electrostatic fields on the freezing parameters and microstructures of frozen button mushrooms. Materials and Methods: Mushroom samples w...
متن کاملOptimal Placement and Sizing of Fault Current Limiter in a Real Network: a Case Study (TECHNICAL NOTE)
In this paper, the effect of number and fault current limiter(FCL) location has been investigated in order to have maximum reduction of short circuit current level in all buses in a real network. To do so, the faulty buses were identified in terms of short circuit current level by computing short circuits on the desired network. Then, while the fault current limit was modeled, its optimal locat...
متن کاملLattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model
Abstract In this paper interparticle potential model of the lattice Boltzmann method (LBM) is used to simulate deformation and breakup of a falling droplet under gravity force. First this model is applied to ensure that the surface tension effect is properly implemented in this model. Two tests have been considered. First, it has been checked an initial square drop in a 2D domain can freely def...
متن کاملBreakup of a Multiple Emulsion Drop in a Uniform Electric Field.
The steady deformation and breakup of emulsion drops in a uniform electric field are considered experimentally. Due to the low volume fraction of inner drops, the emulsions can be effectively assumed as Newtonian fluids with spatial nonuniformity. The measurements of the electrical properties show that the oil-in-water (o/w) emulsion drop behaves like a conducting drop. On the other hand, the w...
متن کامل