Influence of roughness on the admittance of the quartz crystal microbalance immersed in liquids.
نویسندگان
چکیده
The effect of surface roughness on the response of the QCM has been considered, both theoretically and experimentally. A new theoretical approach to the description of the effect of roughness on the response of the QCM is proposed that accounts for the multiscale nature of roughness. Performing experiments in liquids having a wide range of viscosity and density made it possible to understand, for the first time, what characteristics of roughness influence the QCM experiments. The most important conclusion of the current study is that, to understand the experimental data, one has to take into account at least two types of roughness: slight and strong. We found that measurements of the frequency shift observed are not sufficient for the interpretations of the experimental data observed, and a full analysis of the impedance spectrum is called for.
منابع مشابه
Improvement of Sensor Sensitivity of Quartz Crystal Microbalance by Mechanical and Chemical Treatment∗
The influence of quartz plate roughening on the dynamic parameters of quartz resonators has been studied. For this aim AT-cut quartz plates with a diameter of 8 mm, after a standard technological cleaning, are subjected to treatment with abrasive of varying grain sizes: 3, 7, 14 and 20 μm. Piezoquartz resonators are fabricated on these plates with 4 mm Au electrodes. The alterations of resonato...
متن کاملProtein Adsorption to Titanium and Zirconia Using a Quartz Crystal Microbalance Method
Protein adsorption onto titanium (Ti) or zirconia (ZrO2) was evaluated using a 27 MHz quartz crystal microbalance (QCM). As proteins, fibronectin (Fn), a cell adhesive protein, and albumin (Alb), a cell adhesion-inhibiting protein, were evaluated. The Ti and ZrO2 sensors for QCM were characterized by atomic force microscopy and electron probe microanalysis observation, measurement of contact an...
متن کاملOrganic vapor sensing with ionic liquids entrapped in alumina nanopores on quartz crystal resonators.
We report on a concept for vapor sensing with the quartz crystal microbalance where the vapor phase is absorbed into small droplets of an ionic liquid. The liquid is contained in the pores of a nanoporous alumina layer, created on the front electrode of the quartz crystal by anodization. Ionic liquids are attractive for vapor sensing because--being liquids--they equilibrate very fast, while at ...
متن کاملElectroacoustic polymer microchip as an alternative to quartz crystal microbalance for biosensor development.
Laser photoablation of poly(ethylene terephthalate) (PET), a flexible dielectric organic polymer, was used to design an acoustic miniaturized DNA biosensor. The microchip device includes a 100-microm-thick PET layer, with two microband electrodes patterned in photoablated microchannels on one side and a depressed photoablated disk decorated by gold sputtered layer on the other side. Upon applic...
متن کاملWireless-electrodeless quartz-crystal-microbalance biosensors for studying interactions among biomolecules: A review
The mass sensitivity of quartz-crystal microbalance (QCM) was drastically improved by removing electrodes and wires attached on the quartz surfaces. Instead of wire connections, intended vibrations of quartz oscillators were excited and detected by antennas through electromagnetic waves. This noncontacting measurement is the key for ultrahigh-sensitive detection of proteins in liquids as well a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Analytical chemistry
دوره 74 3 شماره
صفحات -
تاریخ انتشار 2002