Sampling Mixer for Software Defined Radio Applications using 0.18μm RF CMOS Technology
نویسنده
چکیده
• Dr. Kwang-Jin Koh for the opportunity to be a part of his research efforts; • Dr. Carl Dietrich, Dr. Leslie Pendleton, and Dr. Roofia Galeshi for the oversight and mentoring services provided throughout the duration of the program; • A special thanks to PhD student Hedieh Elyasi for her patience, as well as her abundant time and effort spent aiding in the learning/research process. • Why Sampling Mixer? Matthew Davis, Chris Davis University of Kentucky: matt. davis@uky. edu, Norfolk State University: c. c. davis40162@spartans. nsu. edu
منابع مشابه
A 0.18μm Cmos Highly Linear Rf down Conversion Mixer for 2.4ghz Applications
A highly linear down conversion mixer with moderate gain used for 2.4GHz RF applications is presented in this paper using 0.18μm CMOS technology. The proposed mixer incorporates current bleeding technique & degenerative resistors to improve linearity and conversion gain. Also the negative feedback configuration of the circuit gives flat conversion gain increasing the overall bandwidth. The simu...
متن کاملA Zero-IF Sub-Harmonic Mixer with High LO-RF Isolation using 0.18 μm CMOS Technology
In this study, we introduce a zero-IF sub-harmonic mixer with high isolation in the 5GHz band using 0.18μm CMOS technology. Placing an LC-Tank between the class AB stage and the mixer core improves the isolation between the LO and RF ports. The measured isolation is obtained with a 48 dB between LO and RF ports; and a 9.5dB conversion gain is acquired while consuming 7mA at 2.5V supply voltage....
متن کاملBroadband Receiver for Software Defined Radio in Giga-hz Range Based on 40nm Si Technology Broadband Receiver for Software Defined Radio in Giga-hz Range Based on 40nm Si Technology
In this paper, a low voltage ultra-wideband RF receiver for Software-Defined Radio (SDR) is presented. In SDR design, the radio frequency (RF) receiver should be able to receive signals over a broadbandwidth so that it can satisfy a variety of different communication standards. In the proposed design, working frequency ranging from 0.1GHz to 6GHz RF front-end for SDR, covering almost all of mat...
متن کاملDiscrete-Time Receivers for Software-Defined Radio: Challenges and Solutions
CMOS radio receiver architectures, based on radio frequency (RF) sampling followed by discrete-time (DT) signal processing via switched-capacitor circuits, have recently been proposed for dedicated radio standards. This paper explores the suitability of such DT receivers for highly flexible softwaredefined radio (SDR) receivers. Via symbolic analysis and simulations we analyze the properties of...
متن کاملIEEE Paper Template in A4 (V1)
In this paper a 3.5 GHz down conversion mixer with 20 MHz IF output signal for location-fixed WiMAX systems is presented. The proposed mixer is implemented with TSMC 0.18μm RF CMOS technology with 1.5V supply voltage which utilizes Current-Bleeding and Current-Reuse techniques to improve noise figure and conversion gain of conventional Gilbert-type structure. This mixer achieves 12 dB of conver...
متن کامل