A Study on Electroless Deposition of Nickel on Nano Alumina Powder Under Different Sensitization Conditions

نویسندگان

  • D. Sameer Kumar
  • K. N. S. Suman
  • P. Rohini Kumar
چکیده

This paper deals with the preparation and characterization of Nickel-coated Alumina ceramic particles by Electroless Plating Technique. Nanosized α-Al2O3 powders of about 50nm in diameter are used for plating. The bath for Electroless Nickel Plating is prepared with NiCl2.6H2O, C6H5NaO7.H2O, NH4Cl and NaH2PO2.H2O. A bath temperature of 85°C, pH value of 8 and stirring time of 20 min is considered to carry out the deposition. The influence of sensitization and activation under different rinsing conditions on the Nickel coating over the Surface of Nano Alumina is studied. The results of these powders are analyzed through morphology, microstructure and phase with scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray diffractometry (XRD) respectively.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Pretreatment Effect on the Properties of Electroless Nano - Crystalline Nickel Phosphorous Coating

the influence of mechanical polishing pre-treatments on steel substrates is investigated in terms of microstructure, deposition rate, adhesion, mechanical and corrosion properties of electroless Ni-P nanocoating with 9-10% wt. of P content. XRD analysis of Ni-P coatings demonstrated the nanocrystalline structure of coating with the grain size of 39 nm. Results showed that pretreatment of substr...

متن کامل

Synthesis and purification of Carbon nanotubes

In this study, multi wall carbon nanotubes (MWCNTs) were synthesized by Chemical vapor deposition (CVD) method using two different catalysts (Fe nanoparticles) and (Ni nanoparticles) with  two different substrates: Quartz and Alumina. Acetylene gas was used as a carbon source and Argon as a carrier gas at different temperatures and different times to study the effects of these parameters on CNT...

متن کامل

Synthesis and purification of Carbon nanotubes

In this study, multi wall carbon nanotubes (MWCNTs) were synthesized by Chemical vapor deposition (CVD) method using two different catalysts (Fe nanoparticles) and (Ni nanoparticles) with  two different substrates: Quartz and Alumina. Acetylene gas was used as a carbon source and Argon as a carrier gas at different temperatures and different times to study the effects of these parameters on CNT...

متن کامل

Investigation of phosphor percent and distribution on surface properties in alumina nanotube substrate

Electroless composite coatings used for achieving of high hardness, lubrication properties, non-stick surface, abrasive coating applications that by impregnation of soft and hard particles into Ni matrix. Electroless Nickel-phosphorous coatings properties and performance is greatly affected by the amount of phosphorus in them. The phosphor in this coating usually varies from 1 to 13 percent. In...

متن کامل

Investigation of phosphor percent and distribution on surface properties in alumina nanotube substrate

Electroless composite coatings used for achieving of high hardness, lubrication properties, non-stick surface, abrasive coating applications that by impregnation of soft and hard particles into Ni matrix. Electroless Nickel-phosphorous coatings properties and performance is greatly affected by the amount of phosphorus in them. The phosphor in this coating usually varies from 1 to 13 percent. In...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016