Average Current Mode Control of Switching Power Supplies
نویسنده
چکیده
Current mode control as usually implemented in switching power supplies actually senses and controls peak inductor current. This gives rise to many serious problems, including poor noise immunity, a need for slope compensation, and peak-to-average current errors which the inherently low current loop gain cannot correct. Average current mode control eliminates these problems and may be used effectively to control currents other than inductor current, allowing a much broader range of topological application.
منابع مشابه
Simulation and properties of randomly switched control systems
Power electronics has made great advances since the introduction of the thyristor in 1958. Even a casual study of consumer electronics, such as computer power supplies, reveals that switched mode power electronics have steadily replaced passive circuits. Switched mode circuits can accommodate higher power densities,' they are lighter, cheaper and easier to control. The use of microprocessors an...
متن کاملOne-Cycle Control of Switching Converters
A new large-signal nonlinear control technique is proposed to control the duty-ratio d of a switch such that in each cycle the average value of a switched variable of the switching converter is exactly equal to or proportional to the control reference in the steady-state or in a transient. One-Cycle Control rejects power source perturbations in one switching cycle; the average value of the swit...
متن کاملVoltage Regulation of a Negative Output Luo Converter Using a PD-PI Type Sliding Mode Current Controller
This paper describes a new design for direct sliding mode method with a high switching frequency using the PD-PI type sliding surface applied to a negative output Luo converter worked in continuous current mode for applications required constant power source such as aerospace applications, medical equipment and etc. Because of the output power and line changes, the converter model is also nonli...
متن کاملImproving Light-Load Efficiency of AC/DC Boost PFC Converters by Nonlinear Control Scheme
Power supply units (PSUs) with an equally shared load current are widely employed for data processing equipment like servers due to their advantages such as easy extension of power processing capability and simple thermal management. This paper presents a method to improve light-load efficiency by reducing load-independent losses such as capacitive turn-on and core losses and reduce the THD of ...
متن کاملA Variable Switching Frequency with Boost Power Factor Correction Converter
This paper presents single phase Power Factor Correction (PFC) with proposed variable switching frequency (VSF) control technique. The increasing of non linear loads such as thyristor rectifiers, switching-mode power supplies, adjustable speed drives, and generate harmonic currents causing various problems to the other equipment connected to the point of common coupling. There are several disad...
متن کامل