Quantitation of mandibular ramus volume as a source of bone grafting.
نویسندگان
چکیده
BACKGROUND When alveolar atrophy impairs dental implant placement, ridge augmentation using mandibular ramus graft may be considered. In live patients, however, an accurate calculation of the amount of bone that can be safely harvested from the ramus has not been reported. The use of a software program to perform these calculations can aid in preventing surgical complications. PURPOSE The aim of the present study was to intra-surgically quantify the volume of the ramus bone graft that can be safely harvested in live patients, and compare it to presurgical computerized tomographic calculations. MATERIALS AND METHODS The AutoCAD software program quantified ramus bone graft in 40 consecutive patients from computerized tomographies. Direct intra-surgical measurements were recorded thereafter and compared to software data (n = 10). In these 10 patients, the bone volume was also measured at the recipient sites 6 months post-sinus augmentation. RESULTS The mandibular second and third molar areas provided the thickest cortical graft averaging 2.8 +/- 0.6 mm. The thinnest bone was immediately posterior to the third molar (1.9 +/- 0.3 mm). The volume of ramus bone graft measured by AutoCAD averaged 0.8 mL (standard deviation [SD] 0.2 mL, range: 0.4-1.2 mL). The volume of bone graft measured intra-surgically averaged 2.5 mL (SD 0.4 mL, range: 1.8-3.0 mL). The difference between the two measurement methods was significant (p < 0.001). The bone volume measured 6 months post-sinus augmentation averaged 2.2 mL (SD 0.4 mL, range: 1.6-2.8 mL) with a mean loss of 0.3 mL in volume. CONCLUSION The mandibular second molar area provided the thickest cortical graft. A cortical plate of 2.8 mm in average at combined second and third molar areas provided 2.5 mL particulated volume. The use of a design software program can improve surgical treatment planning prior to ramus bone grafting. The AutoCAD software program did not overestimate the volume of bone that can be safely harvested from the mandibular ramus.
منابع مشابه
Harvesting Mandibular Ramus Bone Grafts Using Ultrasonic Surgical Device: Report of 20 Cases
Successful osseointegration of the dental implants requires sufficient bone volume surrounding implant site. The mandibular ramus is considered reliable donor site for reconstructing alveolar ridge defects prior to dental implant placement. The aim of this study was to present the clinical efficiency of using ultrasound surgery for harvesting mandibular ramus bone graft. 20 patients (10 male, 1...
متن کاملRamus or chin grafts for maxillary sinus inlay and local onlay augmentation: comparison of donor site morbidity and complications.
BACKGROUND The placement of endosseous implants in edentulous areas is frequently limited by inadequate bone volume of the residual ridge. Local bone grafts from the mandible are a convenient source of autogenous bone for alveolar reconstruction prior to implant placement. PURPOSE The aim of the present study was to document and compare the morbidity and the frequency of complications occurri...
متن کاملStafne bone defect in the ramus of the mandible: a case report
Parotid Stafne bone defect is a very rare and infrequent variant, which is located on the buccal or lingual surface of the mandibular ascending ramus. In this paper, a case of parotid Stafne defect, which was incidentally discovered during dental radiographic examination, is reported. This bone defect was observed as a lucent oval-shaped defect on the lingual aspect of the right mandibu...
متن کاملThe Role of Lingual Bone Grafting in the Treatment of Displaced Edentulous Mandibular Fracture with Severe Atrophy
Introduction: Treatment of edentulous atrophic mandible with severe atrophy is a challenge based on local conditions and systemic diseases confronted by the age group affected. If bone grafting is indicated, it is often used in lateral or inferior aspects of the mandible. Case Report: A 70-year-old male with a unilateral fracture of the atrophied left mandibular body was managed by lingual bon...
متن کاملCostal Grafting in Mandibular Reconstruction
BACKGROUND Reconstruction of mandibular bone defect is a common indication in craniomaxillofacial surgery, and free fibular flap is the gold standard for this indication. However, there are alternatives; nonvascular bone grafting is one of them, and we present the costal grafting for mandibular reconstruction, a classic technique that is reliable, efficient, and produced less morbidity than the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Clinical implant dentistry and related research
دوره 11 Suppl 1 شماره
صفحات -
تاریخ انتشار 2009