Elastohydrodynamic lubrication of faults
نویسندگان
چکیده
The heat flow paradox provides evidence that a dynamic weakening mechanism may be important in understanding fault friction and rupture. We present here a specific model for dynamic velocity weakening that uses the mechanics of well-studied industrial bearings to explain fault zone processes. An elevated fluid pressure is generated in a thin film of viscous fluid that is sheared between nearly parallel surface. This lubrication pressure supports part of the load, therefore reducing the normal stress and associated friction across the gap. The pressure also elastically deforms the wall rock. The model is parameterized using the Sommerfeld number, which is a measure of the lubrication pressure normalized by the lithostatic load. For typical values of the material properties, slip distance and velocity, the Sommerfeld number suggests that lubrication is a~ important process. If the lubrication length scales as the slip distance in an earthquake, the frictional stress during dynamically lubricated large earthquakes is 30% less than the friction with only hydrostatic pore pressure. Elastohydrodynamic lubrication also predicts a decrease in high-frequency (>1 Hz) radiation above a critical slip distance of a few meters. This prediction is well matched by the strong motion data from the 1999 Taiwan earthquake. The observed 2 orders of magnitude variation in scaled radiated energy between small (Mw < 4) and large earthquakes (Mw > 6) is also predicted by the lubrication model.
منابع مشابه
Investigation of Couple Stress Fluid and Surface Roughness Effects in the Elastohydrodynamic Lubrication Problems using Wavelet-Based Decoupled Method
Abstract: The standard decoupled method with Newton-generalized minimum residual procedure performs poorly or may break down when used to solve certain elastohydrodynamic lubrication problems. The authors Zargari et al., 2007 presented decoupled and coupled methods in which the limitations of the decoupled method for some set of physical parameters and slight variation in these values (physical...
متن کاملRelationship between Supplied Oil Flow Rates and Oil Film Thicknesses under Starved Elastohydrodynamic Lubrication
Many studies have already considered starved lubrication. However, there have been no reports on the oil film thicknesses under steady starved EHL (elastohydrodynamic lubrication), where the ultra-low volume of oil supplied per unit time is uniform. The present study examined the relationship between the supplied oil flow rate and oil film thickness under steady starved lubrication. A ball-on-d...
متن کاملComputational Approaches for Modelling Elastohydrodynamic Lubrication Using Multiphysics Software
Elastohydrodynamic lubrication (EHL) modelling plays an important role in engineering design and analysis since a number of important mechanical components operate under EHL conditions. In this paper methods are presented for solving both line and point contact cases using multiphysics software. The advantages, and the overheads, of using such an approach over developing highly specialised, bes...
متن کاملHomogenization of a nonlocal elastohydrodynamic lubrication problem: a new free boundary model
متن کامل
The Elastohydrodynamic Lubrication Force in the Squeeze Motion of Hertzian Deformable Bodies
The elastohydrodynanlic force on two slightly defornlable bodies approaching one another head on is calculated in the limit of small gap sizes and small defornlations by combining Hertz's theory of deformation and lubrication theory. An expression for the lubrication force analytical in the deformation and gap size is obtained. The effect of the gap size, the elasticity and the velocity of appr...
متن کامل