Design of a contactless battery charger for cellular phone
نویسندگان
چکیده
In this paper, the design of a contactless charger for the lithium-ion battery of a cellular phone is presented. In this charger, the primary core of the transformer is in the charger unit and the secondary core is in the telephone. The gap (3 mm) between them is the thickness of the two plastic cases. The transformer core design for the maximum coupling coefficient with the size constraint on the secondary side is presented. Analysis of the primary-side series resonant converter with the loosely coupled transformer is performed, and the design optimization is presented. For the battery-charging control, a simple control circuit is presented and its performance is verified from the experimental results.
منابع مشابه
An Universal, Inductively Coupled Battery Charger for Robot Power Supplies
This report describes the design, construction and test results of an inductively coupled battery charger for robot power supplies. The system should be capable of charging several robot batteries at once from a contactless charging station. The charger should be capable of providing different charging conditions to several different kinds of battery at once. The system should be capable of cha...
متن کاملContactless Power Transfer System for Rapid Charger of Electric Vehicle
A contactless power transfer system for charging electric vehicles requires a high efficiency, a large air gap, and a good tolerance to lateral misalignment and needs to be compact and lightweight. A double-sided winding 10 kW transformer based on a 1.5 kW H-shaped core transformer was developed for a rapid charger. Even though the transformer capacity was increased, the dimensions of the 10 kW...
متن کاملA Bidirectional Contactless Power Transfer System Based on Quantum Modulation
Contactless power transfer is an emerging technology. It is widely used in industrial and consumer electronic products. In this paper, a bidirectional contactless power transfer system for wireless vehicle charger is presented based on quantum modulation method. By applying this novel amplitude modulation method, switching losses and electromagnetic noise are greatly reduced and the whole syste...
متن کاملWireless Arraigning Of Mobile Phones Using Microwaves
Battery life of cellular telephone is dependably been an issue for producers. Individuals are grumbling about their versa tile’s battery life, that they don't have long battery life and they need to charge their telephone a few times. Conveyable electronic gadgets are exceptionally well known these days. As the use of these movable electronic gadgets is expanding, the requests for more battery ...
متن کاملDesign and Analysis of New Level Shifter With Gate Driver for Li-Ion Battery Charger in 180nm CMOS Technology
In this work, the design and analysis of new Level Shifter with Gate Driver for Li-Ion battery charger is proposed for high speed and low area in 180nm CMOS technology. The new proposed level shifter is used to raise the voltage level and significantly reduces transfer delay 1.3ns (transfer delay of conventional level shifter) to 0.15ns with the same input signal. Also, the level shifter with g...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IEEE Trans. Industrial Electronics
دوره 48 شماره
صفحات -
تاریخ انتشار 2001