International Journal of Smart Grid and Clean Energy Synchrophasor measurement based damping estimation and oscillation mode detection using FFT-CWT approach in Japan campus WAMS
نویسندگان
چکیده
The low voltage level synchrophasor measurement data are investigated to estimate the damping ratio and to detect any oscillation mode using Fast Fourier Transform (FFT) and Continuous Wavelet Transform (CWT). Complex Morlet (CM) is selected as a mother wavelet function considering its ability to reveal time and frequency localization simultaneously. A Two Area Four Machine System (TAFMS) model is elaborated using the Power System Analysis Toolbox (PSAT) and the FFT-CWT approach to convince the validity of the proposed method by comparing the two results. Finally, Phasor Measurement Unit (PMU) data from Japan Campus WAMS at some disturbances are evaluated.
منابع مشابه
Survey on Power System Stabilizers Control and their Prospective Applications for Power System Damping using Synchrophasor-Based Wide-Area Systems
Power system oscillation damping remains as one of the major concerns for secure and reliable operation of large power systems, and is of great current interest to both industry and academia. The principal reason for this is that the inception of poorly-damped low-frequency inter-area oscillations (LFIOs) when power systems are operating under stringent conditions may lead to systemwide breakup...
متن کاملGrid Stabilization with PMU Signals- A Survey
This paper presents critical survey along with the novel concept of smart power flow controller with Phasor Measurement Units (PMUs) signals for stability enhancement of a large power system. Also, the current status of Wide Area Measurement Systems (WAMS) and developments in real time applications of synchrophasor technology in power system has been adequately addressed. It has been noticed th...
متن کاملGrid Impedance Estimation Using Several Short-Term Low Power Signal Injections
In this paper, a signal processing method is proposed to estimate the low and high-frequency impedances of power systems using several short-term low power signal injections for a frequency range of 0-150 kHz. This frequency range is very important, and thusso it is considered in the analysis of power quality issues of smart grids. The impedance estimation is used in many power system applicati...
متن کاملLocation methods of oscillation sources in power systems: a survey
The deployment of a synchrophasor-based widearea measurement system (WAMS) in a power grid largely improves the observability of power system dynamics and the operator’s real-time situational awareness for potential stability issues. The WAMS in many power grids has successfully captured system oscillation events, e.g. poorly damped natural oscillations and forced oscillations, from time to tim...
متن کاملFeasibility Study of Using Renewable Energy Sources for a University Campus in Smart Grid Using Fuzzy Method
In this paper, the electrical consumption of Hamedan University is derived of the bills, Then with defining of fuzzy Bus Thermal Coefficient objective function for heating, the amount of available heat selling to university consumer that is produced by Biomass CHP plant is calculated. With the capacity determination of Biomass CHP plant to provide Thermal and electrical energy of university and...
متن کامل