Design of Rectangular Microstrip Patch Antenna Using Stepped Cut at Four Corners for Broadband/ Multiband Application
نویسندگان
چکیده
Design of rectangular microstrip patch antenna (RMPA) using stepped cut at four corners for broadband/multiband application is presented in this paper. Stepped cut at four corner technique is used in order to increase the bandwidth and gain of the antenna. Design and simulation of Modified rectangular microstrip patch antenna are done by CST Microwave Studio software. Four stages are presented for the proposed broadband MRMPA design. The first stage is a single mode RMPA and by increasing steps at the corner of the patch antenna a dual band, multiband and broadband are obtained. As the steps are increased, the antenna's operating bandwidth is also enhanced. The frequencies ranges of this design vary from 900MHZ to 3.5 GHz. Hence this design can be used for GSM (900MHz/1.5GHz), WiFi (2.4GHz), LTE (2.6GHz) and WiMax (3.5 GHz) applications.
منابع مشابه
Broadband Slot Cut Modified Rectangular Microstrip Antenna
The broadband microstrip antenna is realized by cutting a slot at an appropriate position inside the slot. The slot introduces a mode near the fundamental resonance frequency of the patch and realizes broadband response. The broadband patch antenna is also realized by using the proximity feeding technique. Using substrate of thickness greater than 0.080, the bandwidth of slot cut patch antenna...
متن کاملDesign and Development of simple low cost Rectangular Microstrip Antenna for multiband operation
This paper presents the design and development of simple low cost rectangular microstrip antenna for multiband operation. By incorporating U-slot of optimum geometry and open stubs at two opposite corners on the rectangular radiating patch the antenna operates between 1.815 to 9.01 GHz at different frequency bands with a virtual size reduction of 44.84% and gives broadside radiation characteris...
متن کاملEvolution Process of a Broadband Coplanar- Waveguide-fed Monopole Antenna for Wireless Customer Premises Equipment
In this paper a design process of a broadband printed monopole antenna using stepped cut at four corners (CSFC) technique is proposed. The CSFC is a technique that four corners a patch (rectangular/square) of planar monopole antennas are cut in order to enhance the impedance bandwidth. The technique can be used to design any different types of planar monopole antenna in specific frequency range...
متن کاملModified Rectangular Patch Antenna Loaded With Multiple C Slots for Multiple Applications
A new multiple C-slotted microstrip patch antenna is proposed in the present study. A patch antenna is a wide-beam narrowband antenna. The microstrip patch antenna consists of a very thin metallic strip (patch) placed a small fraction of a wavelength above a ground plane. The patch can be designed in any possible shape and normally made of conducting materials such as copper or gold. This study...
متن کاملAntenna Miniaturization Using Fractals (RESEARCH NOTE)
Antenna Miniaturization Using Fractals Richa Garg, AP ECE Deptt., [email protected], J.C.D.C.O.E., Sirsa ABSTRACTThe use of fractal geometry in designing antenna has been a resent topic of interest. Fractal shape has their own unique characteristics that the improved antenna performance can be achieved without degrading the antenna properties. Modern telecommunication system requires antenn...
متن کامل