An optimization-simulation model for a simple LNG process

نویسندگان

  • A. Aspelund
  • T. Gundersen
  • J. Myklebust
  • M. P. Nowak
  • Asgeir Tomasgard
چکیده

A gradient free optimization-simulationmethod for processesmodelledwith the simulator AspenHYSYS is developed. The tool is based on a Tabu Search (TS) and the Nelder-Mead Downhill Simplex (NMDS) method. The local optima that result from the TS are fine-tuned with NMDS to reduce the required number of simulations. The tool has been applied to find the total refrigerant flow rate, composition and the refrigerant suction and condenser pressures that minimize the energy requirements of a Prico process. The main strength of this method is that it has a high probability of obtaining a better solution with significantly fewer simulation runs than other metaheuristic methods. Also, by changing the TS step size it is possible to influence the initial search pattern, thereby taking advantage of already gained process knowledge to decrease the optimization time. Themethod is general and can be applied to other processes modelled in Aspen HYSYS. © 2009 Elsevier Ltd. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Dynamic optimization of the LNG value chain

In operation of a large LNG processing plant there will be uncertainties related to planning and realization of an optimal operation strategy. Results show the importance of including the whole production chain in the optimization. For a test scenario where we look at the event of delayed ship arrival, this gives lower losses than a normal approach where the upstream part of the system and the ...

متن کامل

Optimal Synthesis of a Cascade Refrigeration System of LNG Through MINLP Model for Pure Refrigerant Cycles

 liquefied natural gas (LNG) is the most economical way of transporting natural gas (NG) over long distances. Liquefaction of NG by using vapor compression refrigeration system requires high operating and capital cost. Due to lack of systematic design methods for multistage refrigeration cycles, the conventional approaches of determining optimal cycle configuration are mostly based on trial-an...

متن کامل

Single-cycle mixed-fluid LNG process Part I: Optimal design

In this paper, we discuss the design optimization of a relatively simple LNG process; the PRICO process. A simple economic objective function is stated and used on eight different cases with varying constraints. Important constraints are discussed and the results are compared with the commercial PRICO process and with other publications.

متن کامل

Modeling of plant simulation of MRC plant under variable working conditions and operation optimization

A LNG plant with MRC cycle would not work under the designed condition all the time. It is significant to know the performance of a fixed MRC plant working at changed working condition. The problem involves the problem of plant simulation, which is somewhat similar to but actually different with the process simulation which is used in the design of a LNG plant. A model of MRC plant simulation w...

متن کامل

Optimization of thermal curing cycle for a large epoxy model

Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...

متن کامل

OPTIMIZATION-BASED MONITORING-SUPPORTED CALIBRATION OF A THERMAL PERFORMANCE SIMULATION MODEL

Building performance simulation is being increasingly deployed beyond the building design phase to support efficient building operation. Specifically, the predictive feature of the simulation-assisted building systems control strategy provides distinct advantages in view of building systems with high latency and inertia. Such advantages can be exploited only if model predictions can be relied u...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Computers & Chemical Engineering

دوره 34  شماره 

صفحات  -

تاریخ انتشار 2010