Absolute flatness measurements of silicon mirrors by a three-intersection method by near-infrared interferometry
نویسندگان
چکیده
Absolute flatness of three silicon plane mirrors have been measured by a three-intersection method based on the three-flat method using a near-infrared interferometer. The interferometer was constructed using a near-infrared laser diode with a 1,310-nm wavelength light where the silicon plane mirror is transparent. The height differences at the coordinate values between the absolute line profiles by the three-intersection method have been evaluated. The height differences of the three flats were 4.5 nm or less. The three-intersection method using the near-infrared interferometer was useful for measuring the absolute flatness of the silicon plane mirrors.
منابع مشابه
Absolute Volume Measrumenet of Silicon Spheres at Nmij
The method and devices for absolute volume measurements of 1 kg silicon spheres are described. An interferometer equipped with a direct optical frequency tuning system is used to measure the sphere volume, in which the optical frequency of a diode laser can be tuned continuously over a frequency range of 19 GHz. Accurate frequency changes in the laser produced by this system are used to measure...
متن کاملMeasurement of group velocity dispersion for finite size three-dimensional photonic crystals in the near-infrared spectral region
We measure group delay and group velocity dispersion of silica colloidal photonic crystals in the near-infrared with white light interferometry. While group delay and group velocity dispersion increase with sample thickness, scattering on sample imperfections is found to counteract this development, resulting in group delays lower than theoretically expected. For thin photonic crystals, group v...
متن کاملطراحی، ساخت و مشخصه یابی پله های فازی شیشه ای برای کاربرد در تداخل سنجی جابجایی فاز
In this paper, we report on the design and fabrication of a low-cost phase shifter for application in phase shifting interferometry. Phase shifting interferometry is a powerful method for surface characterization. It uses interference data recorded during a series of predetermined phase shifts to recover the induced phase by the object surface. These controlled phase shifts are typically perfor...
متن کاملLaser Interferometry Hologram Registration for Three- Dimensional Precision Measurements
A hologram registration method is developed for the laser holographic interferometry measurement of the 3D surface profile of objects which are larger than the field of view (FOV). The theory of laser holographic interferometry, including the phase-shifting and multiwavelength tuning, is described. The hologram registration without using targets is elaborated. The cross-correlation analysis is ...
متن کاملSilver-based reflective coatings for micromachined optical filters
Silver films of 40 nm thickness, evaporated on a 300 nm thick low-stress silicon nitride layer, are used as high-quality mirrors operating in the visible and near IR spectral range. Using a silicon nitride membrane under tension, within a square Si frame after bulk micromachining, improves the initial mirror flatness. Two parallel mirrors, with square aperture of up to 2x2 mm and an electrostat...
متن کامل