A Tuned-RF Duty-Cycled Wake-Up Receiver with −90 dBm Sensitivity
نویسندگان
چکیده
A novel wake-up receiver for wireless sensor networks is introduced. It operates with a modified medium access protocol (MAC), allowing low-energy consumption and practical latency. The ultra-low-power wake-up receiver operates with enhanced duty-cycled listening. The analysis of energy models of the duty-cycle-based communication is presented. All the WuRx blocks are studied to obey the duty-cycle operation. For a mean interval time for the data exchange cycle between a transmitter and a receiver over 1.7 s and a 64-bit wake-up packet detection latency of 32 ms, the average power consumption of the wake-up receiver (WuRx) reaches down to 3 μ W . It also features scalable addressing of more than 512 bit at a data rate of 128 k bit / s -1. At a wake-up packet error rate of 10 - 2 , the detection sensitivity reaches a minimum of - 90 dBm . The combination of the MAC protocol and the WuRx eases the adoption of different kinds of wireless sensor networks. In low traffic communication, the WuRx dramatically saves more energy than that of a network that is implementing conventional duty-cycling. In this work, a prototype was realized to evaluate the intended performance.
منابع مشابه
Sensitivity Using an Uncertain-IF Architecture
A dedicated wake-up receiver may be used in wireless sensor nodes to control duty cycle and reduce network latency. However, its power dissipation must be extremely low to minimize the power consumption of the overall link. This paper describes the design of a 2 GHz receiver using a novel “uncertain-IF” architecture, which combines MEMS-based high-Q filtering and a free-running CMOS ring oscill...
متن کاملA 2.4/5.8 GHz 10 μW Wake-Up Receiver With -65/-50 dBm Sensitivity Using Direct Active RF Detection
This paper presents a fully integrated wake-up receiver (WuRx) with direct active RF detection. The RF front-end features a high-sensitivity RF detector embedded with input matching network, obviating the need of RF amplification and LO generation for frequency downconversion. This complete receiver contains an RF detector, IF amplifiers, and a continuous-time ΣΔ ADC to provide inherent anti-al...
متن کاملA BAW based Transceiver used as Wake-Up Receiver
This work presents a BAW based transceiver which can be used as a wake up receiver. The low power consumption can be achieved by using a high duty cycle. In contrast to typical quartz based systems, the BAW based approach allows for a high repetition rate of the duty cycle, which is not possible with conventional systems. The sensitivity of the receiver is -90 dBm at a current consumption of 8 ...
متن کاملA 0.015-mm 60-GHz Reconfigurable Wake-Up Receiver by Reusing Multi-Stage LNAs
An area-efficient 60-GHz wake-up receiver (WuRx) using reconfiguration techniques of multistage low-noise amplifiers (LNAs) is presented. The gain stages of the 60-GHz LNA are reused as the envelope detectors for the wake-up receiver. Therefore, the bulky components such as extra switches between the wake-up receiver and the LNA, additional antennas, and excess input matching network can be rem...
متن کاملWBAN Energy Efficiency and Dependability Improvement Utilizing Wake-Up Receiver
This paper discusses the perspectives of using a wake-up receiver (WUR) in wireless body area network (WBAN) applications with event-driven data transfers. First we compare energy efficiency between the WUR-based and the duty-cycled medium access control protocol based IEEE 802.15.6 compliant WBAN. Then, we review the architectures of state-of-the-art WURs and discuss their suitability for WBAN...
متن کامل