Simulations of Transition Crossing in the Main Injector
نویسنده
چکیده
The design goal for the Fermilab Main Injector (FMI) is to accelerate a minimum of 6 10 protons per bunch through the transition. We present here the results from simulation studies of the transition crossing in the FMI using the particle tracking code ESME[1].
منابع مشابه
Investigation of Temperature Effect in Landau-Zener Avoided Crossing
Considering a temperature dependent two-level quantum system, we have numerically solved the Landau-Zener transition problem. The method includes the incorporation of temperature effect as a thermal noise added Schrödinger equation for the construction of the Hamiltonian. Here, the obtained results which describe the changes in the system including the quantum states and the transition pro...
متن کاملInvestigation the effects of injection pressure and compressibility and nozzle entry in diesel injector nozzle’s flow
Investigating nozzle’s orifice flow is challenging both experimentally and theoretically. This paper focuses on simulating flow inside diesel injector nozzle via Ansys fluent v15. Validation is performed with experimental results from Winkhofler et al (2001). Several important parameters such as mass flow rate, velocity profiles and pressure profiles are used for this validation. Results includ...
متن کاملOrigin of multikilometer earth- and mars-crossing asteroids: A quantitative simulation
Orbital dynamic simulations show that many asteroids in the main asteroid belt are driven toward Mars-crossing orbits by numerous weak mean motion resonances, which slowly increase the orbital ellipticity of the asteroids. In addition, half of the Mars-crossing asteroids (MCAs) transition to Earth-crossing asteroids (ECAs) in less than 20 million years. This scenario quantitatively explains the...
متن کاملAn Uncertainty-based Transition from Open Pit to Underground Mining
There are some large scale orebodies that extend from surface to the extreme depths of the ground. Such orebodies should be extracted by a combination of surface and underground mining methods. Economically, it is highly important to know the limit of upper and lower mining activities. This concern leads the mine designers to the transition problem, which is one of the most complicated problems...
متن کاملConversion of Diesel Engine to Port Injection CNG Engine Using Gaseous Injector Nozzle Multi Holes Geometries Improvement: A Review
This paper is the representation of the computational and experimental methods of a new injector nozzle for a sequential port injection CNG engine. The objective of this study was to review the previous research in the development of gaseous fuel injector for port injection CNG engine converted from diesel engine. Next, a simulation of the fuel flow of the new injector nozzle was made using FLU...
متن کامل