Dynamic Pile Analysis Using CAPWAP and Multiple Sensors
نویسندگان
چکیده
Abstract A new system of multiple dynamic strain sensors and accelerometers embedded in test piles provides direct synchronous measurement of force and acceleration at various locations within a pile during high strain dynamic pile testing. This instrumentation system creates an opportunity to explore side and end bearing pile resistance distribution with a higher level of confidence and reliability than from top measurements alone. Dynamic testing results using embedded transducers are presented for a 16-inch Auger Pressure Grouted Displacement (APGD) pile. The procedure is explained to estimate static side and end bearing components by matching force and/or acceleration data at the pile top and tip using the CAPWAP program. Static load and displacement characteristics at the pile top predicted by CAPWAP are compared to static pile load test results.
منابع مشابه
Dynamic Analysis of Plugged Pipe Piles in Clay
An open ended pipe pile can become plugged when sufficient frictional resistance is developed by the inner soil cylinder within the pile (soil plug), thereby preventing further intrusion of the soil into the pile. When plugging occurs in an impact driven pipe pile, a complex interaction between the pile and soil plug takes place, causing the propagating stress wave to undergo an abrupt change. ...
متن کاملPrediction of End Bearing Capacity for Pre-Bored Steel Pipe Piles Using Instrumented Spt Rods
The standard penetration test (SPT) has been widely used because of its usability, economy, and many correlations with soil properties among other factors. In SPT, hammer energy is an important factor to evaluate and calibrate N values. To measure hammer energy, an instrumented SPT rod was developed considering that stress waves transferring on rods during SPT driving are the same as stress wav...
متن کاملNon-destructive Impulse Response S’mash Method for Concrete Pile Testing
Nowadays, in the civil engineering practice, the pile-building is the most universal type of foundation. It is usually associated with bridges, fly-overs and other civil engineering objects, industrial buildings, tall buildings, chimneys, tanks etc [1]. It is essential to control the quality of concrete piles. The most accepted weight-bearing capacity measurement technique is the static probe l...
متن کاملNonlinear Dynamic Analysis of Pile Foundation Subjected to Strong Ground Motion Using Fiber Elements
In this paper, pile behavior embedded in layered soil deposits subjected to seismic loadings is analyzed using a nonlinear fiber element for simulation of soil – pile interactions. In the created model, both pile and surrounding soil are modeled using fiber elements in a practical Beam on Nonlinear Winkler Foundation (BNWF) concept. Herein, the features of DRAIN–3DX finite element software are ...
متن کاملDynamic Analysis of Embankments Reinforced with Micro-Piles
Application of micro-piles to stabilize unstable slopes has been widely considered in recent years. A micro-pile is a small-diameter (typically less than 300 mm), drilled, and grouted as non-displacement pile that is typically reinforced. The main objective of this study is to evaluate the influence of the micro-pile group on increasing safety factor as well as finding the optimum position of m...
متن کامل