Modeling a dynamically varying mixed sediment bed with erosion, deposition, bioturbation, consolidation, and armoring

Erosion and deposition of bottom sediments reflect a continual, dynamic adjustment between the fluid forces applied to a sediment bed and the condition of the bed itself. Erosion of fine and mixed sediment beds depends on their composition, their vertical structure, their disturbance/recovery history, and the biota that inhabit them. This paper presents a new onedimensional (1D), multi-layer sediment bed model for simulating erosion and deposition of fine and mixed sediments subject to consolidation, armoring, and bioturbation. The distinguishing characteristics of this model are a greatly simplified first-order relaxation treatment for consolidation, a mud erosion formulation that adapts to both Type I and II erosion behavior and is based directly on observations, a continuous deposition formulation for mud that can mimic exclusive erosion and deposition behavior, and straightforward inclusion of bioturbation effects. Very good agreement with two laboratory data sets on consolidation effects is achieved by adjusting only the first-order consolidation rate rc. Full model simulations of three idealized cases based on upper Chesapeake Bay, USA observations are presented. In the mud only case, fluid stresses match mud critical stresses at maximum erosion. A consolidation lag results in higher suspended sediment concentrations after erosional events. Erosion occurs only during accelerating currents and deposition does not occur until just before slack water. In the mixed mud and sand case without bioturbation, distinct layers of high and low sand content form and mud suspension is strongly limited by sand armoring. In the mixed mud and sand case with bioturbation, suspended mud concentrations are greater than or equal to either of the other cases. Low surface critical stresses are mixed down into the bed, constrained by the tendency to return towards equilibrium. Sand layers and the potential for armoring of the bed develop briefly, but mix rapidly. This model offers a relatively simple and robust tool for simulating the complex interactions that can affect muddy and mixed sediment bed erodibility. r 2008 Elsevier Ltd. All rights reserved.