Design and Experimental Results of a 6kW Single-Switch
نویسندگان
چکیده
Abstract — A circuit technique that reduces switching losses of the pulse-width-modulated boost converter is described. The losses are reduced by using a new switch cell that consists of an inductor, a diode, a capacitor, a main switch, and an auxiliary switch. This technique reduces the reverse-recovery-related losses of the rectifier with the inductor that controls the di/dt rate of the rectifier during its turn-off. In addition, the main switch turns off at zero current, while the auxiliary switch turns on at zero voltage. Due to the zero-current switching of the main switch, this technique is particularly suitable for boost converter implementations with insulated-gate bipolar transistors.
منابع مشابه
Analysis and Design of a New Single Switch Non-Isolated Buck-Boost dc-dc Converter
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low v...
متن کاملDesign and Implementation of a New Switch-Diode based Single Source Multilevel Inverter Topology
Multilevel inverters are a new generation of DC-AC converters at medium and high voltage and power levels. These converters have made great strides in the use of industrial applications compared to conventional two-level inverters due to lower harmonic distortion, filter size, EMI and dv/dt. Besides these merits, some disadvantages can be mentioned such as more power electronics devices and com...
متن کاملFully Distributed Modeling, Analysis and Simulation of an Improved Non-Uniform Traveling Wave Structure
Modeling and simulation of communication circuits at high frequency are important challenges ahead in the design and construction of these circuits. Knowing the fact that the lumped element model is not valid at high frequency, distributed analysis is presented based on active and passive transmission lines theory. In this paper, a lossy transmission line model of traveling wave switch (TWSW) i...
متن کاملModular Multilevel Current Source Inverter Using Two-Switch Basic Units
This article is an introduction of a new topology of current source inverter (CSI) which can be alternatively implemented in low/medium power applications. This configuration is organized from series connected sub-multilevel inverters blocks. The basis of the recommended multilevel topology is the connections of many cell units in a decent scheme with the help of H-bridge inverter. The suggeste...
متن کاملDesign and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
متن کامل