Regenerative Heat Treatment of Low Alloy Cast Steel
نویسنده
چکیده
منابع مشابه
Heat Treatment of Metals
Ferrous metals include cast iron, steel, and the various steel alloys, The only difference between iron and steel is the carbon content. Cast iron contains more than 2-percent carbon, while steel contains less than 2 percent. An alloy is a substance composed of two or more elements. Therefore, all steels are an alloy of iron and carbon, but the term “alloy steel” normally refers to a steel that...
متن کاملThe Fracture Mechanisms of an Austenitic Heat Resisting Steel in Copper Converter Atmosphere
The openings of Copper converter in Sarcheshmeh Copper Complex in Iranis made of a heat resisting austenitic steel (Fe-25Cr-12Ni) and many failures have been reported. Understanding the failure mechanism of the alloy helps to develop better alloys for similar complex environments. Samples of as-cast alloy and those taken from failed ones were examined. Optical Microscopy (OM), X-Ray Diffraction...
متن کاملEffect of Overage Hardening Heat Treatment on the Micro Structure and Hardness of Nickel-based Super Alloy Rene-80
Rene-80 nickel-base superalloy as an alloy for production of the jet turbine blades shows high mechanical properties as well as microstructure stability during the high temperature engine operation. In this research, age hardening heat treatment cycle was done on the as-cast Rene-80 superalloy. In the following, microstructure, elemental analysis of phases and macro-hardness of the alloy before...
متن کاملInvestigation of Hardness and Impact Toughness of Zr-Microalloyed Cast Steel
Microalloyed cast steels are a group of microalloyed steels in which reliable mechanical properties could be achieved by heat treatment. In this work, the heat treatment processes were carried out on the cast specimens as the step samples by different thicknesses and Zr content. The results show that after homogenization, variations in thickness have no effect on the hardness. Also, after hea...
متن کاملPrediction of Heat Treatment Distortion of Cast Steel C-rings
Navy C-Ring test parts were made of AISI 1022, 4320, 8625, and CF8M steels and heat treated in a designed experiment to evaluate the commercial heat treatment distortion simulation software DANTE. The parts were machined and then measured with a CMM for original dimensions. The parts were then heated and subsequently quenched in two different immersion orientations in agitated water. Temperatur...
متن کامل