Measured Capacities at 5.8 GHz of Indoor MIMO Systems with MIMO Interference
نویسندگان
چکیده
The capacity performances of two interfering flatfading MIMO links are determined based on measured channels. Time-multiplexing of the links (TDMA), that is, when the MIMO links take turns operating without interference, serves as our baseline case. To this, we compare the spatial-multiplexed case (SDMA), which allows both MIMO links to operate simultaneously. Under SDMA, both open-loop (no channel state information (CSI) is used at the transmitter) and closed-loop (CSI is used at the transmitter) operation are considered. Using data measured by virtual arrays, we explore the effects of line-ofsight (LOS), element spacing, correlated fading, and interference that has various levels of spatial correlation with intended signal. Results show the benefit of wider element spacing in the channels without interference, especially when LOS is available, and with correlated interference if stream control is employed. However, wider spacing is hurtful if stream control is lacking. KeywordsMIMO; channel measurement; wireless communications; spatial multiplexing; virtual antenna array; correlated fading; correlated interference.
منابع مشابه
Measurements of Indoor 16x32 Wideband MIMO Channels at 5.8 GHz - Spread Spectrum Techniques and Applications, 2004 IEEE Eighth International Symposium on
A wideband 16×32 multiple-input multiple-output (MIMO) channel sounder has been developed for the 5.8 GHz band. This paper reports on a series of measurements with the purpose of investigating both temporal and spatial aspects of channel changes in a number of widely different indoor environments. The measurements are carried out using two planar arrays of monopoles. The results include statist...
متن کاملConical Conformal Antenna Design using the CPM Method for MIMO Systems
Abstract- In this article, the design of conformal antennas has been discussed using the characteristic modes (CM) method. For this purpose, the vector wave function(VWF) has been utilized to achieve a two-dimensional mapping of the conformal antenna. In designing and analyzing of cone-shaped antennas applicable for multi-input multi-output (MIMO) systems, the most important goal is to achieve ...
متن کاملA comparison of measured 8×8 MIMO systems with a popular stochastic channel model at 5.2GHz
We compared the average capacities of measured 8×8 MIMO systems with the capacities calculated from a popular stochastic MIMO model. This model separates the influence of fading from the correlation at transmit (TX) and receive (RX) arrays. By using directional RX antennas and a virtual 20×10 TX array with omni antennas we measured the MIMO channel at different RX positions in an indoor office ...
متن کاملA Dynamic Multi-Link MIMO Measurement System for 5.3 GHz
Multi-link MIMO systems, including multi-user MIMO and MIMO with base station cooperation, are essential parts of high-throughput wireless LANs and fourth-generation cellular systems. In order to fully understand such systems, the dynamic channel characteristics of multi-link MIMO channels have to be measured. In this paper we present a measurement setup that enables such measurements and does ...
متن کاملCapacity of Different MIMO Systems Based on Indoor Measurements at 5.2GHz
We compared the average capacities of measured 8 8, 4 4 and 2 2 systems with fixed array size in an indoor office scenario at different receive positions. As expected, correlation either at the transmit or receive side is limiting the MIMO capacity. While the 2 2 system reaches mostly the capacity of an i.i.d. Rayleigh fading channel, the 4 4 and particularly the 8 8 system does not. When we tr...
متن کامل