Estimating the Frequency Response of a Receiver
نویسندگان
چکیده
................................................................................................................................................... i Acknowledgment .................................................................................................................................... ii Table of contents .................................................................................................................................... iii
منابع مشابه
Interference Mitigation of Replay Attacks in GPS Receiver using of Finite Impulse Response Filter
The vulnerability of civil GPS receiver to interference may be intentional or unintentional. Among all types of interference, replay attack intended as the most dangerous intentional one. The signal structure of replay attack is almost the same with the satellite signal. The interference effects can be reduce with the design of an appropriate filter in the receiver. This paper presents two meth...
متن کاملA Wavelet-based Spoofing Error Compensation Technique for Single Frequency GPS Stationary Receiver
Spoofing could pose a major threat to Global Positioning System (GPS) navigation, so the GPS users have to gain an in-depth understanding of GPS spoofing. Since spoofing attack can influence position results, spoof compensation is possible through reducing position deviations. In this paper, a novel processing technique is proposed and the wavelet transform is used to eliminate the impact of sp...
متن کاملESTIMATING THE STRONG-MOTION OF THE DECEMBER 26, 2003 BAM (IRAN), EARTHQUAKE USING STOCHASTIC TECHNIQUES
Abstract : The main objective of this study is estimating the strong motion for the Bam region using the stochastically based seismological models. The two widely used synthetic techniques namely point-source and finite-fault were utilized incorporating the source-path and site parameters into simple function. The decay factor kappa was estimated based on the data obtained from recorded stron...
متن کاملTypical Ka band Satellite Beacon Receiver Design for Propagation Experimentation
This paper presents the design and simulation of a typical Ka band satellite beacon receiver for propagation experimentation. Using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. Satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملPerformance Analysis Of Mono-bit Digital Instantaneous Frequency Measurement (Difm) Device
Instantaneous Frequency Measurement (IFM) devices are the essential parts of anyESM, ELINT, and RWR receiver. Analog IFMs have been used for several decades. However, thesedevices are bulky, complex and expensive. Nowadays, there is a great interest in developing a wideband, high dynamic range, and accurate Digital IFMs. One Digital IFM that has suitably reached allthese requirements is mono-bi...
متن کامل