A 50MS/s 9.9mW pipelined ADC with 58dB SNDR in 0.18µm CMOS using capacitive charge-pumps
نویسندگان
چکیده
In the interest of extending battery life in mobile systems that use pipelined ADCs, several power-efficient pipelined ADCs have recently been proposed. The most promising topologies reported thus far are those that substitute the opamp, which is the largest consumer of power in pipelined ADCs, with alternative and more power-efficient circuits. However, opamp-less pipelined ADCs thus far either: 1) require complex nonlinear calibration [1], 2) are singleended [2], 3) are pseudo-differential [3], or 4) require a sampling scheme that limits linearity (less than 8b ENOB in [3]). In this paper, a low-power pipelined ADC is presented that has significantly lower power consumption than many previous 10b ADCs in the mid-to-high speed range. The ADC does not require power-hungry opamps, and hence achieves similar power savings as in [1-3]. However, unlike prior opamp-free topologies, the ADC: 1) requires only stagegain digital calibration, 2) uses fully differential pipelined stages, and 3) uses a sampling scheme that can achieve high linearity (SFDR of 66dB and better than 9b ENOB).
منابع مشابه
A pipelined SAR ADC with gain-stage based on capacitive charge pump
This paper presents a 14-bit, tunable bandwidth two-stage pipelined successive approximation analog to digital converter which is suitable for low-power, cost-effective sensor readout circuits. To overcome the high DC gain requirement of operational transconductance amplifier in the gain-stage, the multi-stage capacitive charge pump (CCP) was utilized to achieve the gain-stage instead of using ...
متن کامل23-1 A 0.92mW 10-Bit 50-MS/s SAR ADC in 0.13μm CMOS Process
This paper reports a 10-bit 50MS/s SAR ADC with a set-and-down capacitor switching method. Compared to the conventional method, the average switching energy is reduced about 81%. At 50MS/s and 1.2V supply, the ADC consumes 0.92mW and achieves an SNDR of 52.78dB, resulting in an FOM of 52fJ/Conversion-step. Fabricated in a 0.13μm 1P8M CMOS technology, the ADC only occupies 0.075mm active area.
متن کاملDesign of a 12.8 ENOB, 1 kS/s pipelined SAR ADC in 0.35-mu m CMOS
This paper presents a 15-bit, two-stage pipelined successive approximation register (SAR) analog-to-digital converter (ADC) suitable for low-power, cost-effective sensor readout circuits. The use of aggressive gain reduction in the residue amplifier combined with a suitable capacitive array DAC topology in the second stage simplifies the design of the operational transconductance amplifier (OTA...
متن کاملA 10MS/s 11-b 0.19mm2 Algorithmic ADC with Improved Clocking
A 10Ms/s 11-b algorithmic ADC with an active area of 0.19mm is presented. Using an improved clocking scheme, this design overcomes the speed limit of algorithmic ADCs. The proposed ADC employs amplifier sharing, DC offset cancellation, and input memory effect suppression to reduce area and power, and achieve high linearity. The ADC implemented in a 0.13μm thick gate-oxide CMOS process achieves ...
متن کاملA 12 bit 76MS/s SAR ADC with a Capacitor Merged Technique in 0.18µm CMOS Technology
A new high-resolution and high-speed fully differential Successive Approximation Register (SAR) Analog to Digital Converter (ADC) based on Capacitor Merged Technique is presented in this paper. The main purposes of the proposed idea are to achieve high-resolution and high-speed SAR ADC simultaneously as well. It is noteworthy that, exerting the suggested method the total capacitance and the rat...
متن کامل