Increase of Voltage Quality in Industrial Distribution Systems

نویسندگان

  • M. Cernan
  • Z. Muller
  • J. Tlusty
چکیده

This paper deals with the solution of the issue of exceeding the permissible levels for long-term flicker effect Plt in industrial distribution systems. Flicker effect in distribution systems is often exceeded as a result of the connection of electric arc furnaces, which exhibits high variable electrical power in-take. The article shows the benefits of measures on the steel plants, the distribution system operator and the transmission system operator. The main benefits were the installation SVC device and reconstruction of substation 220/110 kV to substation 400/110 kV. Measurements have shown that the flicker has a major impact and configuration system 110 kV. In some cases, exceeded values flicker effect, and therefore the final part of the article deals with the possibility of deployment of active filters low power.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Voltage Sag in Distribution Systems- A review and comparative study (Reasons, Characteristics, Compensations and Detection)

By quick technological advancements in industrial control processes, major industries demand higher power quality. According to IEEE 1159-1995 standard, any problems in voltage, current or freq‌ue‌ncy that lead to the error or malfunctions in electrical equipment are considered as a power quality problem. Among the power quality phenomena, voltage sag has been an important problem for power sys...

متن کامل

Optimal Sitting, Sizing, and Operation of Batteries and Passive Filters to Mitigate Over-voltage and Harmonic Problems in Distribution Networks with High Photovoltaic Penetration

Photovoltaic systems (PVs), despite their many advantages, may have effects such as power quality issues (voltage and harmonics increase), short-circuits level increase, protection issues, and transient stability for network. Some of these effects are due to the high PV penetration, which encounters the network with the over-voltage and harmonics problems. In this paper, the location, size and ...

متن کامل

Influence of Fault Current Limiter in Voltage Drop and TRV Considering Wind Farm

Influence of distributed generation systems in the distribution systems can increase the level of short-circuit current. The effectiveness of distributed generation systems is affected by the size, location, type of distributed generation systems technology, and the methods of connecting to distribution systems. Wind turbine system is the examples of distributed generation source. Not only does...

متن کامل

Multi Objective Optimization Placement of DG Problem for Different Load Levels on Distribution Systems with Purpose Reduction Loss, Cost and Improving Voltage Profile Based on DAPSO Algorithm

Along with economic growth of countries which leads to their increased energy requirements,the problem of power quality and reliability of the networks have been more considered andin recent decades, we witnessed a noticeable growing trend of distributed generation sources(DG) in distribution networks. Occurrence of DG in distribution systems, in addition tochanging the utilization of these sys...

متن کامل

A New Method for Considering Distribution Systems in Voltage Stability Studies

In methods presented to calculate the voltage collapse point, the transmission system is usually the only part of the power system that is completely modeled. Distribution systems are often replaced by aggregate load models because the use of the detailed model of distribution systems in voltage stability analysis not only increases the computation time, but also decreases the probability of co...

متن کامل

The Effectiveness of Dynamic Voltage Restorer with the Distribution Networks for Voltage Sag Compensation

This paper discusses the Dynamic voltage restorer (DVR) operation and control for Voltage sags compensation. DVR is a series connected power electronic based device that can quickly mitigate the voltage sags in the system and restore the load voltage to the pre-fault value. Voltage sag associated with faults in transmission and distribution systems, energizing of transformers, and starting of l...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2015