Reduction of crosstalk on printed circuit board using genetic algorithm in switching power supply
نویسندگان
چکیده
Crosstalk between printed circuit board (PCB) traces in switching power supplies may cause high electromagnetic interference emission. PCB layout plays an important part and a genetic algorithm (GA) is used to produce a layout with reduced crosstalk. A coupling index and a new way of representing a trace for the GA process is presented.
منابع مشابه
Test Power Reduction by Simultaneous Don’t Care Filling and Ordering of Test Patterns Considering Pattern Dependency
Estimating and minimizing the maximum power dissipation during testing is an important task in VLSI circuit realization since the power value affects the reliability of the circuits. Therefore during testing a methodology should be adopted to minimize power consumption. Test patterns generated with –D 1 option of ATALANTA contains don’t care bits (x bits). By suitable filling of don’t cares can...
متن کاملLow Dropout Based Noise Minimization of Active Mode Power Gated Circuit
Power gating technique reduces leakage power in the circuit. However, power gating leads to large voltage fluctuation on the power rail during power gating mode to active mode due to the package inductance in the Printed Circuit Board. This voltage fluctuation may cause unwanted transitions in neighboring circuits. In this work, a power gating architecture is developed for minimizing power in a...
متن کاملTesting Interconnects in a System Chip
Testing of interconnects on a printed circuit board has been studied and the procedure has been standardized in the IEEE 1149.1 (JTAG) standard. The Sysem-on-Chip (SOC) technology allows us to integrate on the same chip, most of the electronics on a PCB. However, since an SOC operates at a much higher speed and has a very large packaging density, testing its interconnects is different. For exam...
متن کاملAn Optimal Selection of Induction Heating Capacitance by Genetic Algorithm Considering Dissipation Loss Caused by ESR (TECHNICAL NOTE)
In design of a parallel resonant induction heating system, choosing a proper capacitancefor the resonant circuit is quite important. The capacitance affects the resonant frequency, outputpower, Q-factor, heating efficiency and power factor. In this paper, the role of equivalent seriesresistance (ESR) in the choice of capacitance is significantly recognized. Optimal value of resonancecapacitor i...
متن کاملAN-690 Design Innovations Address Advanced CMOS Logic Noise Considerations
Noise in an electronic system can be described according to its source. The first category is system-generated noise, i.e., noise generated from the printed board up, such as power distribution and decoupling noise, crosstalk noise, electromagnetic interference (EMI), and transmission line reflections. System noise is a function of signal characteristics such as edge rate, voltage swing, and fr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IEEE Trans. Industrial Electronics
دوره 48 شماره
صفحات -
تاریخ انتشار 2001