Fluctuation microscopy studies of medium-range ordering in amorphous diamond-like carbon films
نویسندگان
چکیده
In this letter, we report fluctuation microscopy studies of medium-range ordering in amorphous diamond-like carbon films and the effect of annealing on this ordering. Annealed and unannealed diamond-like carbon films have almost identical short-range order. Our fluctuation microscopy results, however, indicate the presence of medium range order or clustering in the films on a lateral length scale that exceeds 1 nm. Within the clustered regions, the dominant local ordering appears to be diamond-like, and graphite-like ordering is not observed. Thermal annealing up to 600 °C leads to an increase in diamond-like clustering with no onset of graphite-like clustering. However, after high temperature annealing up to 1000 °C, graphite-like clustering becomes apparent as a result of the conversion of diamond-like carbon to graphite-like carbon. The results on the as-deposited films and films annealed up to 600 °C suggest that a spontaneous medium range ordering process occurs in diamond-like carbon films during and subsequent to film growth, and this may play an important role in stress relaxation. © 2004 American Institute of Physics. @DOI: 10.1063/1.1713048#
منابع مشابه
Effect of Catalyst on the Growth of Diamond-like Carbon by HFCVD
Diamond like carbon (DLC) film was grown by hot filament chemical vapor deposition (HFCVD)technique. In the present work, we investigated the quality of the DLC films groew on the substratesthat were coated with various metal nanocatalysts (Au and Ni). A combination of CH4/Ar/H2 rendersthe growth of carbon nanostructures technique (diamond like carbon). The utilized samples werecharacterized by...
متن کاملPhysical Properties of Reactively Sputter-Deposited C-N Thin Films
This work aims to prepare and study amorphous carbon nitride (CNx) films. Films were deposited by reactive magnetron radiofrequency (RF) sputtering from graphite target in argon and nitrogen mixture discharge at room temperature. The ratio of the gas flow rate was varied from 0.1 to 1. Deposited films were found to be amorphous. Highest Nitrogen concentration achieved was 42 atomic percent whic...
متن کاملPhotoconductivity in highly tetrahedral diamondlike amorphous carbon
A photoconductive effect is observed in tetrahedral amorphous carbon (ta-C) or amorphous diamond films with a high proportion of sp3 bonding and a structure analogous to amorphous silicon. The spectral response is shown to peak at around 750400 nm and extend into the near UV region. The maximum photoresponse coincides wit.h the optical absorption edge. The quantum efficiency of 300 nm thick fil...
متن کاملMorphological Characterization of Combustion Deposited Diamond Crystals and Films
Single crystals and polycrystalline diamond films of several thicknesses were deposited using oxygen/acetylene combustion flame technique. The substrate used was pure polycrystalline molybdenum subjected to mechanical polishing. Quality and microstructural characteristic of diamond produced were investigated using X-Ray diffraction, Raman Spectroscopy, Scanning and Transmission Electron Microsc...
متن کاملHeat treatment of tetrahedral amorphous carbon films grown by filtered cathodic vacuum-arc technique
Tetrahedral amorphous carbon (ta-C ) is a potential low-cost substitute for diamond in certain applications, but little is known of the temperature range over which its desirable properties are retained. The thermal stability of tetrahedral amorphous carbon (ta-C ) films has been investigated by heat treatment of the films at temperatures from room temperature to 450°C in high vacuum, low vacuu...
متن کامل