Real-Time Manganese Phase Dynamics during Biological and Abiotic Manganese Oxide Reduction.
نویسندگان
چکیده
Manganese oxides are often highly reactive and easily reduced, both abiotically, by a variety of inorganic chemical species, and biologically during anaerobic respiration by microbes. To evaluate the reaction mechanisms of these different reduction routes and their potential lasting products, we measured the sequence progression of microbial manganese(IV) oxide reduction mediated by chemical species (sulfide and ferrous iron) and the common metal-reducing microbe Shewanella oneidensis MR-1 under several endmember conditions, using synchrotron X-ray spectroscopic measurements complemented by X-ray diffraction and Raman spectroscopy on precipitates collected throughout the reaction. Crystalline or potentially long-lived phases produced in these experiments included manganese(II)-phosphate, manganese(II)-carbonate, and manganese(III)-oxyhydroxides. Major controls on the formation of these discrete phases were alkalinity production and solution conditions such as inorganic carbon and phosphate availability. The formation of a long-lived Mn(III) oxide appears to depend on aqueous Mn(2+) production and the relative proportion of electron donors and electron acceptors in the system. These real-time measurements identify mineralogical products during Mn(IV) oxide reduction, contribute to understanding the mechanism of various Mn(IV) oxide reduction pathways, and assist in interpreting the processes occurring actively in manganese-rich environments and recorded in the geologic record of manganese-rich strata.
منابع مشابه
Characterization of Copper-Manganese Oxide Catalysts and Their Precursors: Effect of Precipitate Aging upon the Structure and Morphology of Precursors and Catalysts
Copper-manganese oxide catalysts are prepared with an atomic ratio of Cu/Mn=2/1 using a coprecipitation procedure under air atmosphere. The time of aging, i.e., the time that precipitate remains in contact with the precipitating medium, has been varied from 0 (for unaged precursor) to 300 minutes and the effect of precipitate aging time in each atmosphere upon the structure and morphology of di...
متن کاملCopper Manganese Spinel Coating on a Ferritic Stainless Steel for SOFC Application
Nowadays, Because of daily reduction of fossil fuels and environmental problems caused by using them, Fuel Cells attracted a major attention as clean and efficient way of generating electrical power. Solid Oxide Fuel Cells (SOFCs) have many advantages to other fuel cell types. High working temperature of SOFCs caused serious challenges including high oxidation rate of interconnects, Spallation ...
متن کاملComparison of the effect of chromium oxide and magnesium oxide on the mechanical properties and microstructure of alumina-mullite-zirconia composites
Alumina-mullite-zirconia composites were prepared by the reaction sintering method between alumina and zircon powders and the effect of two additives (chromium oxide and manganese oxide)were investigated on their properties. 2 and 4 wt% of each oxide were added to the raw material composition and after pressing, the samples were sintered at 1630°C. The results showed that chromium oxide decreas...
متن کاملBiological versus mineralogical chromium reduction: potential for reoxidation by manganese oxide.
Hexavalent chromium (Cr(vi), present predominantly as CrO4(2-) in water at neutral pH) is a common ground water pollutant, and reductive immobilization is a frequent remediation alternative. The Cr(iii) that forms upon microbial or abiotic reduction often co-precipitates with naturally present or added iron (Fe), and the stability of the resulting Fe-Cr precipitate is a function of its mineral ...
متن کاملRemoval of Fe2+ from Aqueous Solution Using Manganese Oxide Coated Zeolite and Iron Oxide Coated Zeolite
The adsorption of Fe2+ by the manganese oxide coated zeolite (MOCZ) and iron oxide coated zeolite (FOCZ) was studied. Surface properties of adsorbents have been investigated for monitoring their changes and morphology for both of the MOCZ and FOCZ. Main variables namely; contact time, pH, initial concentration of Fe2+, size and dosage of adsorbent have been optimized, and the results contrasted...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Environmental science & technology
دوره 50 8 شماره
صفحات -
تاریخ انتشار 2016