The influence of bicuspid aortic valves on the dynamic pressure distribution in the ascending aorta: a porcine ex vivo model.

OBJECTIVES The aim of the study was to simulate the effect of different bicuspid aortic valve configurations on the dynamic pressure distribution in the ascending aorta. METHODS Aortic specimens were harvested from adult domestic pigs. In Group 1, bicuspidalization was created by a running suture between the left and the right coronary leaflets (n = 6) and in Group 2 by a running suture between the left and the non-coronary leaflets (n = 6). Eleven tricuspid specimens served as controls. Two intraluminal pressure catheters were positioned at the concavity and the convexity of the ascending aorta. The specimens were connected to a mock circulation (heart rate: 60 bpm, target pressure: 95 mmHg). A comparison of the different conditions was also done in a numerical simulation. RESULTS At a distal mean aortic pressure of 94 ± 10 mmHg, a mean flow rate of 5.2 ± 0.3 l/min was achieved. The difference of maximal dynamic pressure values (which occurred in systole) between locations at the convexity and the concavity was 7.8 ± 2.9 mmHg for the bicuspid and 1.0 ± 0.9 mmHg for the tricuspid specimens (P < 0.001). The numerical simulation revealed an even higher pressure difference between convexity and concavity for bicuspid formation. CONCLUSIONS In this hydrodynamic mock circulation model, we were able to demonstrate that bicuspid aortic valves are associated with significant pressure differences in different locations within the ascending aorta compared with tricuspid aortic valves. These altered pressure distributions and flow patterns may further add to the understanding of aneurismal development in patients with bicuspid aortic valves and might serve to anticipate adverse aortic events due to a better knowledge of the underlying mechanisms.