Bonding orthodontics brackets to enamel using experimental composites with an iodonium salt.

OBJECTIVES This study investigated whether the addition of diphenyliodonium chloride (DPC) to experimental resin bonding agents would allow fixation of brackets to enamel using shorter light exposure times. METHODS Photoactivated dimethacrylate-based composites were prepared containing DPC molar concentrations of 0 (control), 0.5 (R05), or 1 per cent (R1). Metallic brackets were bonded to bovine incisors and the bond strengths were evaluated using a shear test. In total, 18 groups were tested (n = 15 per group) defined by three bonding materials (control, R05, or R1), three light-activation time (8, 20, or 40 seconds), and two storage periods (10 minutes or 24 hours). The adhesive remnant index (ARI) was scored under magnification. Data were statistically analysed at a 5 per cent significance level. RESULTS At 10 minutes, the control composite showed lower bond strengths than the DPC-modified bonding agents for all light-activation times. Differences in bond strengths between both DPC-modified agents were not significant. Lower bond strengths at 10 minutes were generally observed for groups light activated for 8 seconds compared with groups light activated for 20 and 40 seconds. At 24 hours, no significant differences were observed among the light-activation times. The bond strengths at 24 hours were higher than the bond strengths at 10 minutes for all groups. A predominance of ARI scores 2 and 3 was generally observed. CONCLUSION The use of a ternary photoactivation system containing an iodonium salt in bonding composites may allow bonding brackets to enamel using reduced light exposure times.