Direct measurement of the passive stiffness of rat sperm and implications to the mechanism of the calcium response.

Glass microprobes were used to measure the stiffness of the flagella of Triton X-100-extracted rat sperm models. The sperm models were treated with 50 microM sodium vanadate and 0.1 mM Mg-ATP to evaluate the stiffness of the passive flagellar structure without the influence of the dynein motor proteins. The passive stiffness was determined to be 4.6 (+/- 1.1) x 10(-19) N x m(2). Rat sperm models exposed to greater than 10(-5) M calcium ions exhibit a strong bend in the basal 40 microm of the flagellum, resulting in a fishhook-like appearance. The torque required to bend a passive rat sperm flagellum into the fishhook-like configuration was determined. The result was compared to the previously published measurement of the torque required to straighten the flagella of rat sperm in the Ca(2+)-induced fishhook configuration [Moritz et al., 2001: Cell Motil. Cytoskeleton 49:33-40]. The torque required to induce a fishhook in a passive flagellum was 2.7 (+/- 0.7) x 10(-14) N x m and the torque to straighten an active Ca(2+)-induced fishhook was 2.6 (+/- 1.4) x 10(-14) N x m. These values are identical within the limit of error of the measurement technique. This finding suggests that the fishhook configuration observed in the Ca(2+) response of rat sperm is the result of a Newtonian equilibrium, where active torque produced by dynein is counterbalanced by an equal and opposite passive torque that results from bending the flagellum. Consistent with this mechanism, the Ca(2+)-induced fishhook configuration is progressively relaxed by incremental increases in sodium vanadate concentration. This supports an active role of the dynein motors in producing the torque for the response. When rat sperm respond to Ca(2+), the bend in the flagellum always forms in the direction opposite the curvature of the asymmetric sperm head. Based on this polarity, the bending torque for the Ca(2+) response must result from the action of the dyneins on outer doublets 1 through 4.