Finite Element Modeling of Chip Formation Process with Abaqus / Explicittm 6 . 3
نویسنده
چکیده
A 2D Finite Element Model (F.E.M.) of chip formation process, set up with an Arbitrary Lagrangian Eulerian (A.L.E.) formulation, proposed in the software Abaqus/Explicit TM v6.3, is shown. The experimental validation showed a good qualitative agreement. Thus, FEM of cutting process can be considered as a promising and reliable tool for machining development within the near future.
منابع مشابه
Chip Formation Process using Finite Element Simulation “Influence of Cutting Speed Variation”
The main aim of this paper is to study the material removal phenomenon using the finite element method (FEM) analysis for orthogonal cutting, and the impact of cutting speed variation on the chip formation, stress and plastic deformation. We have explored different constitutive models describing the tool-workpiece interaction. The Johnson-Cook constitutive model with damage initiation and damag...
متن کاملA Finite Element Study of Chip Formation Process in Orthogonal Machining
This paper deals with the plane strain 2D Finite Element (FE) modeling of segmented, as well as continuous chip formation while machining AISI 4340 with a negative rake carbide tool. The main objective is to simulate both the continuous and segmented chips from the same FE model based on FE code ABAQUS/Explicit. Both the adiabatic and coupled temperature displacement analysis have been performe...
متن کاملEvaluating the Performance of Dowel in PCC Pavement of Roads using ABAQUS Finite Element Software
In Portland Cement Concrete (PCC) pavement of the roads, dowels bar transfers vehicle loading to the unloaded slab. Load Transfer Efficiency (LTE) is used to evaluate dowel bars in PCC pavement. This parameter is defined as the vertical displacement ratio of the loaded slab versus the unloaded slab. In this study, the impact of effective factors (friction coefficient between dowel and concrete ...
متن کاملشبیهسازی المان محدود فرایند برش متعامد و تعیین ضخامت لایه چسبنده به ابزار در ناحیه دوم برش
The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...
متن کاملFinite element modeling of 3 D turning of titanium
The finite element modeling and experimental validation of 3D turning of grade two commercially pure titanium are presented. The Third Wave AdvantEdge machining simulation software is applied for the finite element modeling. Machining experiments are conducted. The measured cutting forces and chip thickness are compared to finite element modeling results with good agreement. The effects of cutt...
متن کامل