Thermal and Phase Transformations Analysis in a Premomet® Steel
نویسنده
چکیده
M. Torres-Lopez, L. Guerra-Fuentes, L. Y. Gomez-Zamorano, M. A. L. Hernandez-Rodriguez, E. Garcia-Sanchez. University Autonomous of Nuevo Leon. Thermal analysis in a PREMOMET® steel has been performed by differential scanning calorimetry (DSC) and highresolution dilatometry. The phase transformation temperatures (Ac1, Ac3, Ms and Mf) of this steel were obtained by the two methods at different heating rates showing good agreement between both techniques. The enthalpy of α-γ transformation for this steel was measured using the thermograms acquired by DSC and microstructure was analyzed by scanning electron microscope (SEM). The results showed that this steel retained a martensitic structure for all conditions.
منابع مشابه
Investigation of Hardness, Morphology and Structural Analysis of NiCrBSi Composite Coating on Plain Carbon Steel
High velocity oxy-fuel (HVOF) is one of the emerging technologies among the thermal spraying techniques, for producing uniform and dense coatings, having high hardness and very low porosity. A NiCrBSi alloy coating was prepared with approximately 400µm thick, on the A516 steel by means of HVOF and was analyzed with regard to its detailed microstructures, phase formation, thickness, roughness an...
متن کاملSolidification and thermal performance analysis of the low carbon steel during the continuous casting process
The present paper evaluates the effect of the nozzle characteristics on the heat transfer and phase change of the low carbon steel during the continuous casting process. A three-dimensional energy equation and a solidification model are used to drive the governing equation of the phase change and temperature distribution. A linear relation is obtained to predict the temperature-dependent of the...
متن کاملشبیهسازی عددی گرمایی- ساختاری فرایند کوئنچ فولادها
In this work, a 3D thermo-microstructural model was developed to simulate the continuous cooling of steel. The model was employed for simulation of cooling process of the gears made from a plain carbon steel (AISI 1045) and a low alloy steel (AISI 4140). Temperature-dependent heat transfer coefficients for two different quenching media were evaluated by experimental and computational methods. ...
متن کاملInvestigation of Effect of Phase Transformations on Mechanical Behavior of AISI 1010 Steel in Laser Forming
In laser forming, phase transformations in the heat affected zone take place under steep cooling rates and temperature gradients, and have a significant affect on the laser forming process and final mechanical properties of products. In this work, phase transformations during laser forming of AISI 1010 steel are experimentally and numerically investigated and the transient volume fraction of ea...
متن کاملDrawing CCCT Diagrams and Investigation of Deformation Effects on Martensite and Bainite Trabsformations in NiCrMoV Steel
In this study, two CCCT diagrams are drawn to be compared with a CCT diagram. The CCCT diagrams represent continuous cooling transformations in stress assisted state. The increased Md and Bd temperatures of CCCT diagrams were also compared with those of the CCT diagrams and the cause was investigated from both thermodynamic and metallurgical viewpoints. Thermodynamic examinations revealed that ...
متن کامل