Piezoresistive Sensing of a Dielectrically Actuated Silicon Bar Resonator
نویسندگان
چکیده
This paper reports on a dielectrically actuated and piezoresistively sensed 4.41 GHz silicon bar resonator with an electromechanical Q (Qem) of 8180. The 2-port piezoresistive transconductance measurement performed provides a promising alternative to capacitive measurement at high frequencies, where nominal and feed-through capacitance often dominates the output signal. The electromechanical f·Q product of the silicon-based resonator is 3.6×10 s, the highest reported to date for a silicon resonator using a direct 2-port measurement. INTRODUCTION Silicon-based high frequency electromechanical resonators offer low power, small footprint, high-Q solutions for a variety of applications including microprocessing, RF communications, and sensor networks. In recent years, much of MEMS resonator research has focused on different mechanisms for driving and sensing acoustic resonance at frequencies exceeding 1 GHz. Promising transduction methods include solid dielectric capacitive transduction [1,2], piezoelectric transduction [3,4], and air-gap capacitive actuation with piezoresistive sensing [5]. The authors previously demonstrated the internal dielectric transduction of a 4.51 GHz silicon bar resonator [2]. The 3 and 9 longitudinal-mode harmonics of the device were excited and detected capacitively with dielectric films sandwiched inside the resonator body at displacement nodes (Figure 1). The 9 harmonic resonance at 4.51 GHz with a mechanical quality factor of 11,200, demonstrated a 9.8 dB improvement in signal strength over the 3 harmonic at 1.5 GHz. The resulting mechanical f·Q product of 5.1×10 s is the highest measured to date in silicon. The analytical and experimental study of internal dielectric transduction performed in [2,6] indicates improved transduction efficiency with increasing frequency, enabling mechanical resonance at previously unattainable frequencies. A three-port scalar mixer measurement [7] was used to characterize the internal dielectrically transduced resonator. However, the large nominal and feed-through capacitance inherent in high-frequency capacitive sensing makes such resonators impractical in most integrated CMOS applications. In this work, the 9 harmonic of a longitudinal mode silicon bar resonator is detected in a two port measurement, coupling the benefits of internal dielectric capacitive actuation with the piezoresistive sensing demonstrated by van Beek et al [5]. THEORY Capacitive Actuation and Sensing Internal dielectric transduction employs capacitive drive and sense to excite and detect acoustic resonance. In [2], a longitudinal-mode bar resonator is driven and sensed electrostatically with thin vertical dielectric layers, as shown in Figure 1. The resonator body is biased to VDC, and a harmonic excitation of amplitude vin is applied to the drive electrode at the resonant frequency. The amplitude of vibrations of the n harmonic resonance is given by ⎥ ⎦ ⎤ ⎢ ⎣ ⎡ ⎟ ⎠ ⎞ ⎜ ⎝ ⎛ + − ⎟ ⎠ ⎞ ⎜ ⎝ ⎛ − = 2 sin 2 sin 2 2 2 2 0 g k d k g k d k g L Y n v V Q U n n n n in DC f π ε (1) suspension beams anchor anchor A A’ dielectric film A A’ Figure 1: Schematic of internal dielectric transduced longitudinalmode bar resonator. The dielectric films (yellow) are incorporated into the resonant mode shape. A cross section of the bar along AA’ is illustrated on the right. The 9th harmonic longitudinal mode is shown, with dielectric films for driving resonance positioned at displacement nodes. where Q is the quality factor, and Y and ρ are the Young’s modulus and mass density of the resonator, respectively. Here, f ε is the dielectric permittivity, g is the dielectric thickness, d is the position of the dielectric along the bar, A is the transduction area, and L n kn π = is the resonance wave number. The 2-port motional impedance out in X i v R ≡ for the n harmonic of the resonator is given by ( ) ( ) 2 sin cos 2 2 2 4
منابع مشابه
Acoustic Resonance in an Independent-gate Finfet
This paper demonstrates the acoustic resonance of an Independent-Gate (IG) FinFET driven with internal dielectric transduction and sensed by piezoresistive modulation of the drain current through the transistor. An acoustic resonance at 37.1 GHz is obtained with a quality factor of 560, corresponding to an f.Q product of 2.1x10. The demonstrated hybrid NEMS-CMOS technology can provide RF CMOS c...
متن کاملThe resonant body transistor.
This paper introduces the resonant body transistor (RBT), a silicon-based dielectrically transduced nanoelectromechanical (NEM) resonator embedding a sense transistor directly into the resonator body. Combining the benefits of FET sensing with the frequency scaling capabilities and high quality factors (Q) of internal dielectrically transduced bar resonators, the resonant body transistor achiev...
متن کاملDifferential reflectance modulation sensing with diffractive microstructures
Related Articles Microelectromechanical strain and pressure sensors based on electric field aligned carbon cone and carbon black particles in a silicone elastomer matrix J. Appl. Phys. 112, 094324 (2012) Wheatstone bridge piezoresistive sensing for bulk-mode micromechanical resonator Appl. Phys. Lett. 101, 193505 (2012) Distant mechanical sensors based on cholesteric liquid crystals Appl. Phys....
متن کاملTop-Down CMOS-NEMS Polysilicon Nanowire with Piezoresistive Transduction
A top-down clamped-clamped beam integrated in a CMOS technology with a cross section of 500 nm × 280 nm has been electrostatic actuated and sensed using two different transduction methods: capacitive and piezoresistive. The resonator made from a single polysilicon layer has a fundamental in-plane resonance at 27 MHz. Piezoresistive transduction avoids the effect of the parasitic capacitance ass...
متن کاملThermally Actuated Low Impedance MEMS Resonators for Mass Sensing Applications
This paper presents high-Q thermally actuated micromechanical resonators suitable for sensory applications under atmospheric pressure. Single crystal silicon resonators with resonance frequencies in the 250 KHz to 1.5MHz range were fabricated using a single-mask fabrication process on SOI substrates. The resonators were operated in a one-port configuration in their in-plane resonance mode with ...
متن کامل