A 120-W -Band Spatially Combined Solid-State Amplifier
نویسندگان
چکیده
In this paper, we present new results in the development of a broad-band spatial power-combining system implemented in a standard X-band waveguide environment. Using 24 off-the-shelf GaAs monolithic-microwave integrated-circuit (MMIC) power amplifiers integrated with tapered-slot antenna arrays, the new combining circuit produced up to 126-W maximum power output with a gain variation of 1.9 dB within the band of interest (8–11 GHz). This hybrid circuit combiner is transparent to the device technology, and also provides an excellent heat-sinking capacity, sustaining as much as 415 W of dc power consumed by the MMIC amplifiers. The modular architecture allows easy maintenance, variable output power level, and modular assembly. Results on graceful degradation are also presented, showing superb tolerance to device failure.
منابع مشابه
Non-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملNonlinear Analysis of a Power Amplifier inc C Band and Load Pull Technique Calculation USING VOLTERRA SERIES
In recent years, nonlinear circuit analysis techniques have been extensively investigated. One of the most important reasons is the application development of solid-state devices at microwave frequencies. Different methods have been used to analysis large signal behavior of these devices. In this paper load-pull curves (one of design requirement) are obtained using Volterra series. The main adv...
متن کاملHigh Power SSPA Based on GaN HEMTs for S-band Military Radars
In this paper, we have developed a high power solid-state power amplifier (SSPA) for Sband military radars. The SSPA consists of a high power amplifier (HPA) module combined GaN based power amplifier pallets, a drive amplifier (DA) module, a digital control module and a power supply unit. The SSPA shows the total output power of 62 dBm in S-band.
متن کاملBroadband Spatially Combined Amplifier Array Using Tapered Slot Transitions in Waveguide
Most reported spatially combined or quasioptical amplifier arrays exhibit resonant narrowband performance (<10%) and have not addressed thermal management issues. We report a waveguide-based spatial combining scheme using broadband tapered-slot transitions, capable of realizing full waveguide band coverage (40% fractional bandwidth) with good thermal properties. An X-band prototype using eight ...
متن کامل