Calculating the fine structure of a Fabry-Perot resonator using spheroidal wave functions.

ساختار مد طولی برای تشدیدگر حلقوی ناهم سطح

 The structure of longitudinal modes of a passively Q-switched, non-planar unidirectional ring-resonator,with Nd:YAG active medium is described in this article. Two different techniques are used to study the longitudinal mode structure of the laser resonator. At first, the fast-fourier transform technique is applied for analyzing the mode beating of the optical fields by intensity frequency str...

Full-wave Analysis of a Fabry-perot Type Resonator

Correction of Thermal Deviations in Fabry-Perot Resonator Based Measurements of Specific Gases in Millimeter Wave Bands

Due to the thermal expansivity of the material used in the Fabry-Perot resonator mirrors, the resonator cavity length can change and this might therefore have an impact on the resonant frequency during high-resolution spectroscopy measurements. Based on measurements and simulations, this paper discusses the influences of temperature on the precise determination of gas attenuation measured in a ...

Amplification of the Signal Intensity of Fluorescence-Based Fiber-Optic Biosensors Using a Fabry-Perot Resonator Structure

Fluorescent biosensors have been widely used in biomedical applications. To amplify the intensity of fluorescence signals, this study developed a novel structure for an evanescent wave fiber-optic biosensor by using a Fabry-Perot resonator structure. An excitation light was coupled into the optical fiber through a laser-drilled hole on the proximal end of the resonator. After entering the reson...

Mirror-orientation noise in a Fabry-Perot interferometer gravitational wave detector.

The influence of angular mirror-orientation errors on the length of a Fabry-Perot resonator is analyzed geometrically. Under conditions in which dominant errors are static or vary slowly over time, the analysis permits a simple prediction of the spectrum of short-term cavity length fluctuations resulting from mirror-orientation noise. The resulting model is applicable to the design of mirror co...