Potential drop based model to analyze electrode passivation by fouling from phenolic compounds
نویسندگان
چکیده
Dielectric interface would be formed on the electrode surface during the analysis or disposal of many phenolic compounds due to electro-polymerization. This could cause electrode passivation, also called electrode fouling, which is indicated by the continuously decaying current signal. This paper proposed a model based on the potential drop across the fouling layer, which is helpful for deep understanding of the electrode passivation/fouling process. This model successfully fitted the experimental results.
منابع مشابه
Modeling analysis of electrode fouling during electrolysis of phenolic compounds
During the electrochemical analysis or disposal of most of phenolic compounds, insulated polymeric substrates are created and cover the electrode surface. This can cause the signal current to decay over time, which is called electrode fouling or electrode passivation. This paper describes a model based on the potential drop across the fouling layer that is helpful for deeper understanding of th...
متن کاملTheorical Investigation of Linear Response for Passivated Metallic Electrode Under Potential Step (RESEARCH NOTE)
The transient response of passivated metallic electrode system under potential step was analyzed based on a linear model, and a technique for calculating the parameters characterizing the growth and dissolution of passive film was proposed. It is believed that the information which is expected to be gained from the impedance measurement can be obtained by this technique and that this technique ...
متن کاملStudy on Electrochemical Oxidation of m-Nitrophenol on Various Electrodes Using Cyclic Voltammetry
The electrochemical oxidation behavior of m-nitrophenol (m-NP) was studied comparatively on glassy carbon electrode, Pt electrode, PbO2 electrode, SnO2 electrode, and graphite electrode using cyclic voltammetry. The cyclic voltammetry measurements were performed in acidic (1 M H2SO4, pH 0.4), neutral (1 M Na2SO4, pH 6.8), and...
متن کاملAn Exfoliated Graphite-Based Bisphenol A Electrochemical Sensor
The use of an exfoliated graphite (EG) electrode in the square wave voltammetric detection of bisphenol A (a model phenolic pollutant) in water, whereby the phenolic electrode fouling challenge is mitigated, is described. The oxidation peak of BPA was observed at about 0.45 V in phosphate buffer solution at pH 10. The current response exhibited a linear relationship with the concentration over ...
متن کاملAdvanced Dynamic Simulation of Membrane Desalination Modules Accounting for Organic Fouling
A reliable dynamic simulator (based on a sound process model) is highly desirable for optimizing the performance of individual membrane modules and of entire desalination plants. This paper reports on progress toward development of a comprehensive model of the complicated physical-chemical processes occurring in spiral wound membrane (SWM) modules, that accounts for the...
متن کامل