Plastic Behavior of Metallic Damping Materials under Cyclical Shear Loading

نویسندگان

  • Chaofeng Zhang
  • Longfei Wang
  • Meiping Wu
  • Junhua Zhao
چکیده

Metallic shear panel dampers (SPDs) have been widely adopted in seismic engineering. In this study, axial and torsional specimens of four types of metallic damping materials, including three conventional metallic steels as well as low yield strength steel 160 (LYS160), were tested in order to investigate the material response under repeated large plastic strain and low cycle fatigue between 10 and 30 cycles. The present study demonstrated that both the deformation capacity and fatigue performance of LYS160 were underestimated by the conversion from the traditional uniaxial tensile test. The main difference in the failure mechanism between LYS160 and the three conventional materials was determined from the scanning electron microscopy data. The dominant failure mode in LYS160 is stable interlaminate slip and not bucking. Our results provide physical insights into the origin of the large deformation capacity, which is an important foundation for the lightweight design of SPDs.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Improved Behaviour of Accordion Metallic Dampers Affected by the Increasing Number of Layers

In recent years, thin-walled accordion tubes under axial cyclic loading due to their appropriate energy absorption mechanism and behavioral characteristics were suggested as hysteretic metallic dampers. The effectiveness of accordion metallic damper (AMD) to protect and mitigate the response of structures under seismic loading is well established both experimentally and analytically. In this pa...

متن کامل

Design Spectrum for Near Fault Ground Motions Considering Frequency-Dependence of CH/SC Material Behavior Regarding Laboratory and Field Shear Wave Velocity (Vs)

Introduction One-dimensional site response analysis is widely performed to account for local site effects during an earthquake. Most of these approaches assume that dynamic soil properties are frequency independent. Laboratory test results as well as in-situ testing show that shear modulus and damping ratio are dependent on the frequency of loading. Although the amplification factor at ground ...

متن کامل

Fracture behaviors under pure shear loading in bulk metallic glasses

Pure shear fracture test, as a special mechanical means, had been carried out extensively to obtain the critical information for traditional metallic crystalline materials and rocks, such as the intrinsic deformation behavior and fracture mechanism. However, for bulk metallic glasses (BMGs), the pure shear fracture behaviors have not been investigated systematically due to the lack of a suitabl...

متن کامل

Effects of Degree of Consolidation and Anisotropic Consolidation Stresses on Shear Modulus and Damping Ratio of Cohesive Soils at Low Strain

During consolidation process of saturated cohesive soil the soil stiffness increases. Increase of the effective stress due to dissipation of excess pore pressure causes additional stiffness of soil mass. This phenomenon has a very important effect on the behavior of saturated cohesive soils during dynamic loading. In the current investigation the changes in maximum shear modulus. Gmax and dampi...

متن کامل

Substructure Model for Concrete Behavior Simulation under Cyclic Multiaxial Loading

This paper proposes a framework for the constitutive model based on the semi-micromechanical aspects of plasticity, including damage progress for simulating behavior of concrete under multiaxial loading. This model is aimed to be used in plastic and fracture analysis of both regular and reinforced concrete structures, for the framework of sample plane crack approach. This model uses multilamina...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 9  شماره 

صفحات  -

تاریخ انتشار 2016