Sensor fusion for online tool condition monitoring in milling

This article may be used for research, teaching and private study purposes. Any substantial or systematic reproduction, redistribution , reselling , loan, sub-licensing, systematic supply or distribution in any form to anyone is expressly forbidden. The publisher does not give any warranty express or implied or make any representation that the contents will be complete or accurate or up to date. The accuracy of any instructions, formulae and drug doses should be independently verified with primary sources. The publisher shall not be liable for any loss, actions, claims, proceedings, demand or costs or damages whatsoever or howsoever caused arising directly or indirectly in connection with or arising out of the use of this material. The objective of this paper is to combine a direct sensor (vision) and an indirect sensor (force) to create an intelligent integrated tool condition monitoring (TCM) system for online monitoring of flank wear and breakage in milling, using the complementary strengths of the two types of sensors. For flank wear, images of the tool are captured and processed in-cycle using successive moving-image analysis. Two features of the cutting force, which closely indicate flank wear, are extracted in-process and appropriately pre-processed. A self-organizing map (SOM) network is trained in a batch mode after each cutting pass, using the two features derived from the cutting force, and measured wear values obtained by interpolating the vision-based measurement. The trained SOM network is applied to the succeeding machining pass to estimate the flank wear in-process. The in-cycle and in-process procedures are employed alternatively for the online monitoring of the flank wear. To detect breakage, two features in time domain derived from cutting force are used, and the thresholds for them are determined dynamically. Again, vision is used to verify any breakage identified in-process through the cutting force monitoring. Experimental results show that this sensor fusion scheme is feasible and effective for the implementation of online tool condition monitoring in milling, and is independent of the cutting conditions used.