1 μJ, sub-500 fs chirped pulse amplification in a Tm-doped fiber system.

نویسندگان

  • R Andrew Sims
  • Pankaj Kadwani
  • Alex Sincore Lawrence Shah
  • Martin Richardson
چکیده

We demonstrate a Tm-doped fiber laser system producing ~300 fs pulses with 1 μJ energy, corresponding to peak powers greater than 3 MW. Pulses of 150 fs with 30 nm spectral bandwidth and 3 nJ pulse energy are generated in a Raman-soliton self-frequency shift amplifier, then stretched to ~160 ps using a chirped Bragg grating. The 60 MHz oscillator repetition rate is reduced to 100 kHz using an electro-optic modulator. After a single-mode fiber preamplifier and a large-mode-area fiber power amplifier, pulses were compressed using a folded Treacy grating setup to below 500 fs with up to 1 μJ pulse energy. To the best of our knowledge, this is the highest energy yet demonstrated as well as the first demonstration of peak powers exceeding 1 MW from a Tm:fiber laser system.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High power 2 µm femtosecond fiber laser.

A high power polarization maintaining femtosecond Tm-doped fiber laser system is demonstrated. A chirped fiber Bragg grating with normal dispersion was used to compensate the anomalous dispersion from the regular fiber in the 2 µm seed oscillator to generate mode locked pulses with a pulse repetition rate of 30.84 MHz. After chirped pulse amplification, an amplified power of 78 W was obtained. ...

متن کامل

Mid-infrared optical parametric amplifier based on a LGSe crystal and pumped at 1.6 μm.

We demonstrate the generation of 22.6 μJ of combined energy at 3 μm for sub-300fs pulses at a repetition rate of 1 kHz using a LGSe optical parametric amplifier (OPA). The LGSe OPA is pumped by the 140-fs 1.6 μm pulses from a 300-mW KTA optical parametric chirped pulse amplifier (OPCPA) based on an all-optical synchronization scheme. By using a highly-nonlinear fiber, the output of an erbium-do...

متن کامل

High pulse energy 2 µm femtosecond fiber laser.

In the paper, a 2 µm high energy fs fiber laser and amplification system is presented based on Tm doped fibers. The seed laser was designed to generate pulse train at 2024 nm at a repetition rate of 2.5 MHz. An AOM was used as a pulse picker to further lower the repetition rate down to 100 kHz. Two-stage fiber pre-amplifiers and a high energy large mode area (LMA) fiber amplifier were used to b...

متن کامل

High Power Femtosecond Fiber Chirped Pulse Amplification System for High Speed Micromachining

The need for improved precision in a wide variety of micromachining applications has driven scientific interest in ultrashort pulse lasers. Despite numerous demonstrations of reduced heat effect and improved processing quality, the utility of such lasers has been limited by the heavy demands placed upon laser performance. In addition to high contrast laser pulses with minimal pulse-to-pulse flu...

متن کامل

Multi-kilowatt, all-fiber integrated chirped-pulse amplification system yielding 40x pulse compression using air-core fiber and conventional erbium-doped fiber amplifier.

We present a totally fiber integrated chirped-pulse amplification system using air-core photonic bandgap fiber and a conventional erbium-doped fiber amplifier. ~40-ps input pulses, generated in a Mach-Zehnder modulator, were stretched and spectrally broadened in a dispersion-shifted fiber before being amplified and subsequently compressed in 10 m of anomalously-dispersive photonic bandgap fiber...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Optics letters

دوره 38 2  شماره 

صفحات  -

تاریخ انتشار 2013