TiO2 Nanotube Array Sensor for Detecting the SF6 Decomposition Product SO2
نویسندگان
چکیده
The detection of partial discharge through analysis of SF(6) gas components in gas-insulated switchgear, is significant for the diagnosis and assessment of the operating state of power equipment. The present study proposes the use of a TiO(2) nanotube array sensor for detecting the SF(6) decomposition product SO(2), and the application of the anodic oxidation method for the directional growth of highly ordered TiO(2) nanotube arrays. The sensor response of 10-50 ppm SO(2) gas is tested, and the sensitive response mechanism is discussed. The test results show that the TiO(2) nanotube sensor array has good response to SO(2) gas, and by ultraviolet radiation, the sensor can remove attached components very efficiently, shorten recovery time, reduce chemical poisoning, and prolong the life of the components.
منابع مشابه
Preparation and Application of TiO2 Nanotube Array Gas Sensor for SF6-Insulated Equipment Detection: a Review
Since Zwilling and co-workers first introduced the electrochemical anodization method to prepare TiO2 nanotubes in 1999, it has attracted a lot of researches due to its outstanding gas response and selectivity, making it widely used in gas detection field. This review presents an introduction to the sensor applications of TiO2 nanotube arrays (TNTAs) in sulfur hexafluoride (SF6)-insulated equip...
متن کاملA Pt-Doped TiO2 Nanotube Arrays Sensor for Detecting SF6 Decomposition Products
The detection of partial discharge and analysis of SF6 gas components in gas-insulated switchgear (GIS) is important for the diagnosis and operating state assessment of power equipment. The use of a Pt-doped TiO2 nanotube arrays sensor for detecting sulfur hexafluoride (SF6) decomposition products is proposed in this paper. The electrochemical pulse deposition method is employed to prepare the ...
متن کاملAdsorption of SF6 decomposed gas on anatase (101) and (001) surfaces with oxygen defect: A density functional theory study
The detection of partial discharge by analyzing the components of SF6 gas in gas-insulated switchgears is important to the diagnosis and assessment of the operational state of power equipment. A gas sensor based on anatase TiO2 is used to detect decomposed gases in SF6. In this paper, first-principle density functional theory calculations are adopted to analyze the adsorption of SO2, SOF2, and ...
متن کاملGas Sensitivity and Sensing Mechanism Studies on Au-Doped TiO2 Nanotube Arrays for Detecting SF6 Decomposed Components
The analysis to SF6 decomposed component gases is an efficient diagnostic approach to detect the partial discharge in gas-insulated switchgear (GIS) for the purpose of accessing the operating state of power equipment. This paper applied the Au-doped TiO2 nanotube array sensor (Au-TiO2 NTAs) to detect SF6 decomposed components. The electrochemical constant potential method was adopted in the Au-...
متن کاملApplication of TiO2 Nanotubes Gas Sensors in Online Monitoring of SF6 Insulated Equipment
Titanium dioxide nanotube arrays (TNTAs) are a typical three-dimensional nanomaterial. TNTA has rich chemical and physical properties and low manufacturing costs. Thus, TNTA has broad application prospects. In recent years, research has shown that because of its large specific surface area and nanosize effect, the TNTAs have an enormous potential for development compared with other nanostructur...
متن کامل