An Appraisal of the Transient Response of a D.c. Shumt Motor Using Matlab/simulink under No Loading and Full Loading Conditions
نویسندگان
چکیده
Electric machines are used to generate electrical power in power plants and provide mechanical work in industries. This paper describes the MATLAB/SIMULINK realization of the performance of a D.C. shunt motor and introduces model power components to use computer simulation as a tool for conducting transient by using Simulink and SimPower System. These simulation models were employed to calculate the speed (N), torque (T), armature current (Ia), input and output power (Pin and Pout), losses (Plosses) and efficiency (η) for the motor at no load and load conditions. The results obtained using MATLAB were compared with the practical results, the ratio of error is about (1-2) % was found. The SIMULINK was written in MATLAB languages version (6.5).
منابع مشابه
FPGA based Fuzzy Logic Control for Single Phase Multilevel Inverter
A single phase cascaded inverter consisting of two full bridges creates a five level AC output voltage. Due to switch combination redundancies, there are certain degrees of freedom to generate the five level AC output voltage. A single phase Pulse Width Modulation (PWM) Multil Level Inverter (MLI) produces AC output voltage of desired magnitude and frequency. The purpose of voltage controller f...
متن کاملThree dimensional static and dynamic analysis of thick plates by the meshless local Petrov-Galerkin (MLPG) method under different loading conditions
In this paper, three dimensional (3D) static and dynamic analysis of thick plates based on the Meshless Local Petrov-Galerkin (MLPG) is presented. Using the kinematics of a three-dimensional continuum, the local weak form of the equilibrium equations is derived. A weak formulation for the set of governing equations is transformed into local integral equations on local sub-domains by using a uni...
متن کاملProgressive Damage Analysis of Laminated Composites using Continuum Damage Mechanics
In this paper, progressive damage and global failure of composite laminates under quasi-static, monotonic loading are investigated using 3D continuum damage mechanics. For this purpose, a finite element program has been developed using an eight-node 2D layered element including layer-wise plate theory. Damage analysis of a single orthotropic layer under various uniform in-plane and transverse l...
متن کاملA New Approach of Modelling, Simulation of Mppt for Photovoltaic System in Simulink Model
This paper presents the design and simulation for maximum power point tracking (MPPT) for photovoltaic system, which includes a high-efficiency dc-dc boost converter with a modified incremental conductance algorithm. The converter can draw maximum power from the PV panel for a given solar insolation and temperature by adjusting the duty cycle of the converter. The modelling procedure for the ci...
متن کاملAdaptive and intelligent control of permanent magnet synchronous motor (PMSM) using a combination of fuzzy logic and gray wolf algorithm under fault condition
Nowadays, permanent magnet synchronous motors have been widely used in industry due to the elimination of excitation losses, longer life and higher efficiency. Errors in engine and drive systems are unavoidable during operation. Therefore, a suitable scenario should be considered for when these systems fail. If the necessary predictions and control algorithms are not considered for the error co...
متن کامل