Properties of C 4 F 8 inductively coupled plasmas . I . Studies of Ar Õ c - C 4 F 8 magnetically confined plasmas for etching of SiO 2
نویسندگان
چکیده
Gas mixtures containing c-C4F8 /Ar are commonly used for the plasma etching of dielectric materials such as SiO2 . To quantify the dependence of fundamental plasma parameters of systems using these mixtures, inductively coupled plasmas in the pressure range of 6–20 mTorr, with and without magnetic confinement, were investigated. Measurements were also made in pure Ar and O2 to provide a comparison baseline. We found that use of magnetic confinement strongly influences the total ion flux, ion composition, and ion energy distributions in these discharges. Magnetic confinement increases the ion saturation current density, as measured with a Langmuir probe, most effectively at the lowest pressure examined here ~6 mTorr!. The increase in current density generally decreases as the pressure increases. Mass spectroscopic measurements of the ion flux showed that the CF ion flux dominates in C4F8 discharges, both with and without magnetic confinement. When Ar is added to C4F8 discharges with magnetic confinement, the CF2 1 and CF3 1 ion fluxes increase, and CF3 1 becomes the dominant fluorocarbon ion. The ion energy distributions with and without magnetic field indicate that the plasma potential is generally lower for the magnetically confined discharges, although these trends are not monotonic when diluting C4F8 with Ar. Etching rates of SiO2 , Si, and photoresist are higher with magnetic confinement, while etching yields are lower. The chemical compositions of passively deposited fluorocarbon films on Si, as measured by x-ray photoemission spectroscopy, differ little with and without magnetic confinement for varying C4F8 /Ar gas compositions. © 2004 American Vacuum Society. @DOI: 10.1116/1.1697482#
منابع مشابه
Effect of radio frequency bias power on SiO2 feature etching in inductively coupled fluorocarbon plasmas
We present and discuss results obtained in studies of the mechanisms underlying various feature size dependencies of SiO2 etching in inductively coupled fluorocarbon plasmas. The variation of the fluorocarbon deposition rate and the SiO2 etch rate with both feature size and rf bias power has been measured in a variety of constant aspect ratio features for both an etch stop (C3F6 /H2) and a none...
متن کاملElectronbeam controlled radio frequency discharges for plasma processing
Related Articles Atomic-scale silicon etching control using pulsed Cl2 plasma J. Vac. Sci. Technol. B 31, 011201 (2013) Low-pressure inductively coupled plasma etching of benzocyclobutene with SF6/O2 plasma chemistry J. Vac. Sci. Technol. B 30, 06FF06 (2012) Reaction mechanisms of oxygen plasma interaction with organosilicate low-k materials containing organic crosslinking groups J. Vac. Sci. T...
متن کاملSurface kinetics and plasma equipment model for Si etching by fluorocarbon plasmas
Plasma-surface interactions during plasma etching are important in that, in addition to determining the rate and quality of the etch, they can also influence the properties of the bulk plasma. To address this coupling of bulk and surface processes the surface kinetics model ~SKM! was developed as a module in the two-dimensional hybrid plasma equipment model ~HPEM! with the goal of combining pla...
متن کاملPhoto-assisted etching of silicon in chlorine- and bromine-containing plasmas
Cl2, Br2, HBr, Br2/Cl2, and HBr/Cl2 feed gases diluted in Ar (50%–50% by volume) were used to study etching of p-type Si(100) in a rf inductively coupled, Faraday-shielded plasma, with a focus on the photo-assisted etching component. Etching rates were measured as a function of ion energy. Etching at ion energies below the threshold for ion-assisted etching was observed in all cases, with Br2/A...
متن کاملComparative analysis of barium titanate thin films dry etching using inductively coupled plasmas by different fluorine-based mixture gas
In this work, the inductively coupled plasma etching technique was applied to etch the barium titanate thin film. A comparative study of etch characteristics of the barium titanate thin film has been investigated in fluorine-based (CF4/O2, C4F8/O2 and SF6/O2) plasmas. The etch rates were measured using focused ion beam in order to ensure the accuracy of measurement. The surface morphology of et...
متن کامل