Analysis of Flow in Cylindrical Mixing Chamber
نویسنده
چکیده
The article deals with numerical investigation of axisymmetric subsonic air to air ejector. An analysis of flow and mixing processes in cylindrical mixing chamber are made. Several modes with different velocity and ejection ratio are presented. The mixing processes are described and differences between flow in the initial region of mixing and the main region of mixing are described. The lengths of both regions are evaluated. Transition point and point where the mixing processes are finished are identified. It was found that the length of the initial region of mixing is strongly dependent on the velocity ratio, while the length of the main region of mixing is dependent on velocity ratio only slightly. Keywords—Air ejector, mixing chamber, CFD.
منابع مشابه
Computational Study of Radiative and Convective Heat Transfer in a Cylindrical Combustion Chamber
In this paper, the effect of cold air on the fluid flow inside the cylindrical combustion chamber and its wall temperature distribution have been studied computationally, taking into account the effect of radiative heat transfer from hot gases. The results have been compared with the case that radiative heat transfer was neglected. It is observed that the reattachment length increases when incr...
متن کاملLaminar mixing of high-viscous fluids by a cylindrical chaotic mixer
Laminar mixing of glycerin in a chaotic mixer is carried by means of the blob deformation method. The mixer was a cylindrical vessel with two rotational blades which move along two different circular paths with a stepwise motion protocol. The flow visualization was performed by marking of the free surface of the flow with a tracer. The effects of controlling parameters such as rotational speed ...
متن کاملMixing of the Immiscible Liquids in the Entrance Region of a T-Type Chamber Using Laser Induced Fluorescence (LIF) Method
A Laser Induced Fluorescence technique (LIF) has been used to study the mixing behavior of two emerging streams in a T-Type mixing chamber. A mixing index on the basis of digital image light intensities is calculated. It has been shown that averaging over more than 800 images leads to a stable mixing index calculation. Moreover, the effect of equal and un-equal flow rates on the mixing behavior...
متن کاملImproving Cyclone Efficiency by Recycle and Jet Impingement Streams
In this paper a new process is presented for improving efficiency of cyclone de-dusting systems. The cyclone is coupled with a specially designed cylindrical chamber which includes a rotating tube inside it with air impinging nuzzles, drilled on the peripheral surface of the tube. The nuzzles help in pushing and throwing the particles to the outer radius distances during downward flow of du...
متن کاملDesign of an Inhalation Chamber to Expose Laboratory Animals with Suspended Particulate Matter by Numerical Simulation Method
Introduction: Usually, in the toxicological studies of airborne particulate pollutants, inhalation exposure chambers are used for providing and distributing the test atmosphere uniformly and stability in the respiratory zone of laboratory animals. The purpose of this study was to design, evaluate and optimize a whole-body exposure chamber, specifically for small laboratory animals exposed to pa...
متن کامل