Analysis of Multilayered Printed Circuit Boards using Computed Tomography

نویسندگان

  • Samuel Fox
  • Greg Perry
چکیده

Computed Tomography is a technique that can be performed using a set of X-ray images to re-create a three dimensional dataset which contains information about internal structure. Analysis of multilayered Printed Circuit Boards with their components using this technique allows for the non destructive evaluation of internal layers of failed boards. This report presents the results of computerised tomography on multilayered Printed Circuit Boards using a SkyScan 1076.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

IEEE Standard 1149.1 (JTAG) in the 3200DX Family

Due to the increasing complexity of circuit boards, testing loaded boards is becoming prohibitively expensive and more difficult to perform. Board complexity has resulted from the rapid development of surface-mount technology and from the use of multilayered boards. Finer pin spacing and the use of double-sided boards also have contributed to the increased cost and difficulty of traditional tes...

متن کامل

X-ray Industrial Computed Laminography (ICL) Simulation Study of Planar Objects

X-ray Industrial Computed Laminography (ICL) is a non-destructive three-dimensional (3D) imaging technique for high aspect ratio planar objects such as printed circuit boards and stacked IC. Complementing to the established method of X-ray Industrial Computed Tomography (ICT), ICL is based on tilt orientation of the planar object with respect to incident X-ray beam by a defined angle.The tilt a...

متن کامل

The effects of etching and deposition on the performance and stress evolution of open through silicon vias

In order to embed more functionality and performance into the same design space, 3D IC integration technology is one of the routes towards further miniaturization of ICs and consequently, printed circuit boards. 3D TSV (through silicon via) stacking of wafers or dies requires die-to-die interconnections to conduct electricity and heat. Typically micro bump contacts with solder (e.g. AgSn) and C...

متن کامل

Extraction of Tin and Copper by Acid Leaching of PCBs

Printed circuit board (PCB) waste is generally dumped as a landfilling or treated pyrometallurg ically, which consumes enormous power, generates hazardous gases and also destroys valuable PCB components. For recycling of the components, they must be separated from the printed circuit boards which is a cumbersome task. For its simplification, the rate of d issolution of solder with acids like Hy...

متن کامل

A Wavelet-based Approach for Disturbance Line Identification in Printed Circuit Boards

The problem of identifying disturbance lines in printed circuit boards is addressed. Identification is achieved by estimating the disturbance frequency and the separation distance between the coupled lines. Frequency estimation uses a wavelet coefficients thresholding method to reconstruct the interference caused by the disturbance line. The separation distance is computed using two empirical l...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014