Ultrafine metallic Fe nanoparticles: synthesis, structure and magnetism
نویسندگان
چکیده
The results of the investigation of the structural and magnetic (static and dynamic) properties of an assembly of metallic Fe nanoparticles synthesized by an organometallic chemical method are described. These nanoparticles are embedded in a polymer, monodisperse, with a diameter below 2 nm, which corresponds to a number of around 200 atoms. The X-ray absorption near-edge structure and Mössbauer spectrum are characteristic of metallic Fe. The structural studies by wide angle X-ray scattering indicate an original polytetrahedral atomic arrangement similar to that of β-Mn, characterized by a short-range order. The average magnetic moment per Fe atom is raised to 2.59 µ(B) (for comparison, bulk value of metallic Fe: 2.2 µ(B)). Even if the spontaneous magnetization decreases rapidly as compared to bulk materials, it remains enhanced even up to room temperature. The gyromagnetic ratio measured by ferromagnetic resonance is of the same order as that of bulk Fe, which allows us to conclude that the orbital and spin contributions increase at the same rate. A large magnetic anisotropy for metallic Fe has been measured up to (3.7 ± 1.0)·10(5) J/m(3). Precise analysis of the low temperature Mössbauer spectra, show a broad distribution of large hyperfine fields. The largest hyperfine fields display the largest isomer shifts. This indicates a progressive increase of the magnetic moment inside the particle from the core to the outer shell. The components corresponding to the large hyperfine fields with large isomer shifts are indeed characteristic of surface atoms.
منابع مشابه
Low Temperature Synthesis of α-Fe2O3 Nano-rods Using Simple Chemical Route
Iron oxide (Fe2O3) is widely used as a catalyst, pigment and gas sensitive material. In this article, α-Fe2O3 nano-rods were first synthesized via a simple chemical method using iron(III) nitrate 9- hydrate (Fe(NO3)3.9H2O) as precursor. XRD pattern showed that the iron oxide nanoparticles exhibited alpha-Fe2O3 (hematite) structure in nanocrystals. The single-phase α- Fe2O3 nano-rods were prepa...
متن کاملStudy the stability of Si, Ge, Fe and Co in the interior surface of metallic carbon nanotube for hydrogen storage
In this article, we have performed calculations for studying the stability of the carbon group elements such as Si and Ge and also the magnetic elements like Fe and Co via first principle investigations. We found that Si and Ge decoupled from the interior surface of carbon nanotubes, this fact was independent in curvature, radius, conductivity and numbers of atoms in the carbon nanotubes. But t...
متن کاملExploring the potential of metallic nanoparticles within synthetic biology.
The fields of metallic nanoparticle study and synthetic biology have a great deal to offer one another. Metallic nanoparticles as a class of material have many useful properties. Their small size allows for more points of contact than would be the case with a similar bulk compound, making nanoparticles excellent candidates for catalysts or for when increased levels of binding are required. Some...
متن کاملCTAB-assisted of Fe2O3/CeO2 nanosized prepared by coprecipitation method
Recently, cerium oxide (CeO2) nanoparticles have been widely used in engineering andmedical sciences due to the diversity of their applications. Fe-Ce nanoparticles were synthesized bysimple co-precipitation method via iron nitrate (Fe(NO3)3.9H2O) and cerium nitrate (Ce(NO3)3.6H2O) asprecursor in the presence of cetyltrimethylammonium bromide (CTAB) surfactant. The samples wer...
متن کاملSynthesis of Fe-doped CeO2 Nanoparticles Prepared by Solgel Method
Nanomaterials have achieved remarkable technological advances in bulk materials due to their excellent physical, chemical and biological properties. cerium oxide (CeO2) nanostructured doped with Fe ions is attractive due to improvement in redox properties, transport property and surface-to-volume ratio. In this research, Fe-doped CeO2 nanoparticles (NPs) were prepared by s...
متن کامل