A Case Study to Setup Optimum Process Parameters in Thermal Deburring for Removing the Burr in Barrel of Fuel Injector
نویسندگان
چکیده
– Deburring is the finishing technique that is very essential for the manufacturing of precise components. Deburring process with greater efficiency and full automation is an extremely difficult task. Thermal deburring offers a potential solution to such problems. For successful utilization of thermal deburring, more intensive research including parameters analysis of the process is still required. The parameters which affect the performance of thermal deburring are mixture ratio of oxygen & hydrogen gas, pressure of oxygen & hydrogen gas mixture, Impulse of the chamber and size of the burr. A case study is conducted to find the optimum process parameters for thermal deburring using taguchi approach.. Key words–– Deburring, Thermal deburring, Optimization, Taguchi approach
منابع مشابه
Conversion of Diesel Engine to Port Injection CNG Engine Using Gaseous Injector Nozzle Multi Holes Geometries Improvement: A Review
This paper is the representation of the computational and experimental methods of a new injector nozzle for a sequential port injection CNG engine. The objective of this study was to review the previous research in the development of gaseous fuel injector for port injection CNG engine converted from diesel engine. Next, a simulation of the fuel flow of the new injector nozzle was made using FLU...
متن کاملExperimental study of the diesel injector nozzle sediment effect on fuel spray behavior
High pressure amount of fuel in new generation diesel engines’ injector equipped with multiple and small nozzle holes has created significant improvement in the outgoing spray behavior and engine performance. On the other hand, poor fuel quality and injector nozzle embedded in high temperature combustion chamber form fundamental deposits on the nozzle leading to fuel spray inappropriate behavio...
متن کاملRotating injector in DI diesel engine for improving performance and reducing NOx emission
Oxides of Nitrogen are the major emission from a diesel engine. It is due to heterogeneous diffusion combustion system with fuel-rich regions, which produce high local temperature around the periphery of the spray where high formation rate of NO is promoted. Various techniques are therefore employed to reduce the NOX emission like EGR, SCR, etc. In this present work a rotating injector is a tec...
متن کاملNumerical investigation the effect of accumulator on reducing the pressure waves in a common rail fuel injection system of diesel engine
Pressure fluctuations during fuel injection are one of the factors that negative effect on performance of diesel engine. These fluctuations are caused by the rapid opening and closing of the nozzles and the creation of pressure waves in the fuel rail. One way to control these pressure fluctuations is to change the injector design and use an accumulator in the injector. This study is performed t...
متن کاملDeasphalting of Olefin Pyrolysis Fuel Oil by Combination of Chemical–Physical Methods
This work investigates the effect of different conditions of PFO thermal cracking from two PFO samples on liquid, solid and gas product yield and asphaltene removal efficiency in a new designed experimental setup. No need to use a catalyst, simple operating system and experiment conditions, the ability to use water as a cheap carrier gas and high asphaltene extraction efficiency without the use...
متن کامل