Effect of sputtering pressure-induced roughness on the microstructure and the perpendicular giant magnetoresistance of FeÕCr superlattices
نویسندگان
چکیده
We have studied the connection between structure and magnetism of Fe/Cr superlattices as a function of sputtering pressure. To measure the perpendicular giant magnetoresistance, we have fabricated microstructured Fe/Cr pillars embedded in SiO2 and interconnected with Nb electrodes. Because of the uniform current distribution in the Nb electrodes and the minimization of the superlattice-electrode contact resistance, the method allows a simple and independent measurement of the perpendicular superlattice resistance and giant magnetoresistance. A detailed quantitative structural analysis by x-ray diffraction, transmission electron microscopy, and high spatial resolution electron-energy-loss spectroscopy imaging, was correlated with magnetization and anisotropic magnetotransport properties. Structural characterization of @Fe~3 nm!/Cr~1.3 nm!#20 superlattices indicate that the roughness increases monotonically with pressure. The current perpendicular to the plane giant magnetoresistance was also found to increase with pressure. This is interpreted as arising from an enhanced spin-dependent scattering.
منابع مشابه
Enhancement of perpendicular and parallel giant magnetoresistance with the number of bilayers in FeÕCr superlattices
We have correlated a detailed quantitative structural analysis by x-ray diffraction, transmission electron microscopy, and high spatial resolution electron energy-loss spectroscopy imaging, with the magnetization and anisotropic magnetotransport properties in sputtered Fe/Cr superlattices. To accomplish this, we developed a technique for magnetotransport measurements in metallic superlattices w...
متن کاملMagnetic properties of Co/Re hcp„101̄0... superlattices
hcp(101̄0) Co/Re superlattices were grown via magnetron sputtering on Al2O3(112̄0) substrates. The thickness of the Co layers was approximately 1.8 nm with the Re layer thickness varying between 0.5 nm and 3.0 nm. Low angle x-ray reflectivity revealed that for our growth conditions the interfacial roughness is approximately 0.4 nm in each material at each interface. High angle x-ray diffraction, ...
متن کاملInterfacially dominated giant magnetoresistance in FeÕCr superlattices
J. Santamaria,* M.-E. Gomez, M.-C. Cyrille, C. Leighton, Kannan M. Krishnan, and Ivan K. Schuller Department of Physics, University of California–San Diego, La Jolla, California 92093-0319 Materials Sciences Division, National Center for Electron Microscopy, Lawrence Berkeley Laboratory, University of California–Berkeley, Berkeley, California 94720 ~Received 14 August 2001; published 3 December...
متن کاملConnection between giant magnetoresistance and structure in molecular-beam epitaxy and sputtered Fe/Cr superlattices.
We have performed a comparison of magnetoresistance and structure of epitaxial and textured Fe/Cr superlattices grown by molecular-beam epitaxy ~MBE! and magnetron sputtering with either ~110! and ~100! orientations on a variety of substrates. MBE samples grown along the ~100! orientation, exhibit narrower rocking curves ~mosaic spread! and lower saturation resistivities than sputtered samples....
متن کاملGiant magnetoresistance in Co/Cu multilayers sputtered with Kr
The critical condition for the giant magnetoresistance (GMR) effect has not yet been fully clarified. Reports on the MR ratio of C o / C u multilayers (MLs) disagree as to whether the interfacial roughness or crystallinity of the MLs is the cause. The film morphology is significantly affected by sputtering conditions such as sputtering gas and pressure. This paper presents some results of the m...
متن کامل