Calculation of Pulse Propagation in Coaxial Cables with Multi-layered Insulation System
نویسنده
چکیده
R. Jobava, D. Pommerenke., R. Heinrich**, W. Kalkner**, A. Gheonjian Tbilisi State University, 3 Chavchavadze Ave., Tbilisi 380028, Georgia Fax: ++99532 290845 e-mail: lae@,resonan.ge Hewlett Packard 8000 Foothills Blvd., Roseville, CA, 95747, Mailstop 5603 Fax: 916 685 3082, e-mail: [email protected] "Technical University Berlin Einsteinufer 1 1, 10587 Berlin, Germany Fax: ++49-30-314-21142, e-mail: [email protected]
منابع مشابه
Changes in signal transmission speed in coaxial cables through regulating the foam structure of the polyethylene dielectric section
Polyolefins have been widely used in the electrical insulation and cable industry in recent years. One of the main usages of these materials is dielectric insulation in coaxial cables. Low attenuation and high signal transmission speed are among the desired features in coaxial cables. The role of polyethylene foam on signal transmission speed in the coaxial cables is the main focus of this stud...
متن کاملAnalytical D’Alembert Series Solution for Multi-Layered One-Dimensional Elastic Wave Propagation with the Use of General Dirichlet Series
A general initial-boundary value problem of one-dimensional transient wave propagation in a multi-layered elastic medium due to arbitrary boundary or interface excitations (either prescribed tractions or displacements) is considered. Laplace transformation technique is utilised and the Laplace transform inversion is facilitated via an unconventional method, where the expansion of complex-valued...
متن کاملCable Diagnostics with On-voltage Time Domain Reflectometry
In this paper a diagnostics technique is presented for localization of degraded regions along an XLPE insulated power cable. The diagnostics would help to develop a strategy for condition based maintenance of old XLPE power cables. A design of the diagnostics system and results of measurements performed on two power cables are presented. The measurements data is processed in order to localize t...
متن کاملHigh Voltage Pulse Generator by connecting Normal Coaxial Cables in series and in parallel without using Blumlein method
In order to carry out the simulation of the electrical noise, a pulse generator with fast rise time is needed. For this reason, the pulse generator using a coaxial cable is usually used. The pulse generator consists of a DC power supply, a charging resistor, a coaxial cable, a relay, and a terminator. Even the same voltage as charge voltage was outputted when the termination of the impedance wa...
متن کاملHigh Frequency Characteristics of Medium Voltage XLPE Power Cables
The response of a cable can be used to analyze the variation of the material characteristics along its length. For diagnosis of possible ageing, it is necessary to know how cable design, material properties and cable insulation ageing affects the wave propagation. A cable model has therefore been worked out based upon the high frequency properties of the cable insulation and conductor systems. ...
متن کامل