Modeling and Simulation of Heat and Mass Transfer in Oil Palm Fruit Digestion Process
نویسنده
چکیده
This paper describes a model and simulation of heat transfer and mass transport phenomena during digestion process of oil palm fruits using Comsol Multiphysics software ver. 4.4. Prior to the simulation, some experimental works were conducted to measure water and oil transport and heat transfer. The measured average water diffusivity coefficients of sterilised oil palm fruits were 3.03E-09 m/s, 2.4545E-08 m/s, and 9.433E-09 m/s for intact fruits, a-b axis sliced, and c-axis sliced fruits respectively. The diffusivity coefficients of oil release from mesocarp were 1.04E-08 m/s, 4.5578E-09 m/s, and 4.083E-09 m/s respectively. For simulation purposes, the fruit was modeled as a half ellipsoid shape. Digestion time was 30 minutes and the initial bulk and fruit temperatures were at 95C and 28C respectively. It was proven in both experiment and simulation that rupturing fruits had significant impact on higher water absorption to the mesocarp and more oil released from the fruit. Based on both simulation and experiment, the fruit reached uniform temperature of 95 C after five minutes of heating. __________________________________________________________________________________________
منابع مشابه
Simulation of Stresses Induced by Heat and Mass Transfer in Drying Process of Clay-like Material
Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...
متن کاملModeling and Simulation of Heat Transfer Phenomenon in Steel Belt Conveyer Sulfur Granulating Process
Complex heat transfer phenomena (including unsteady state conduction, convection and solidification processes) occur in steel belt conveyer sulfur granulating method. Numerical simulation of this technique is performed via a comprehensive and multifaceted one dimensional model. Since the air situated between the adjacent sulfur pastilles is essentially stagnant, therefore, the surface tempe...
متن کاملSupercritical Fluid Extraction of β-Carotene from Crude Palm Oil Using CO2 in a Bubbler Extractor: Mass Transfer Study
In this study, the diffusivity and volumetric mass transfer coefficients for the extraction of β-carotene from crude palm oil using CO2 solvent in supercritical fluid were determined in the pressure range of 7.5-17.5 MPa and temperature range of 80-120 ºC. For this purpose, a statistical method was applied in order to minimize the number of experiments required. The volumetric ma...
متن کاملThree-dimensional modeling of transport phenomena in a planar anode-supported solid oxide fuel cell
In this article three dimensional modeling of a planar solid oxide fuel cell (SOFC) was investigated. The main objective was to attain the optimized cell operation. SOFC operation simulation involves a large number of parameters, complicated equations, (mostly partial differential equations), and a sophisticated simulation technique; hence, a finite element method (FEM) multiphysics approach ...
متن کاملAlkaline Earth Metal Oxide Catalysts for Biodiesel Production from Palm Oil: Elucidation of Process Behaviors and Modeling Using Response Surface Methodology
Four different alkaline earth metal oxides i.e. MgO, CaO, SrO and BaO were used as heterogeneous catalysts for biodiesel production from palm oil. Effects of critical process variables i.e. reaction time, methanol to oil ratio and temperature were investigated. The results were then fitted to a historical design to study the Analysis of Variance (ANOVA), to characterize interactions between...
متن کامل