Anomalous Heat Generated by Electrolysis Using a Palladium Cathode and Heavy Water

نویسنده

  • E. K. Storms
چکیده

Samples of palladium sheet supplied by IMRA Japan were tested for anomalous energy production using electrolysis in heavy water and a sensitive calorimeter. Several samples were found to produce significant power above that being applied to produce electrolysis. This behavior was found to correlate with certain properties of the palladium metal. In addition, the anomalous heat was shown to originate at the cathode

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Anomalous Heat Produced by Electrolysis of Palladium using a Heavy-Water Electrolyte

Significant heat was generated for about 740 min when a sample of palladium foil was electrolyzed as the cathode in D2O+LiOD. A very stable Seebeck calorimeter is described and used to make the measurements. The source of this anomalous energy is unknown. However, the observed energy and production of unexpected elements based on EDX examination are similar to the behaviors claimed by many peop...

متن کامل

EXCESS HEAT REPRODUCIBILITY AND EVIDENCE OF ANOMALOUS ELEMENTS AFTER ELECTROLYSIS IN Pd|D2O+H2SO4 ELECTROLYTIC CELLS

Electrolyte temperature is a key factor in excess heat production using Pd|D2O+H2SO4 electrolytic cells. Best results are obtained when the electrolyte temperature is close to the boiling point. Stable excess heat is generated by events on or near the Pd cathode surface. In addition to the stable excess heat, heat bursts are sometimes observed. These occurred most frequently in experiments usin...

متن کامل

Electrochemical Loading of Hydrogen and Deuterium Into Palladium and Palladium-Boron Alloys

Excess power production and other anomalous effects have been observed during the electrolysis of heavy water using palladium and palladium-boron alloys as the cathode materials. This study focused on hydrogen and deuterium loading into palladium and palladium-boron alloys. Improved calorimetry provided for the detection of the exothermic heat of absorption of deuterium into palladium and palla...

متن کامل

Miles, M

Anomalously high radiation counts were observed using several different Geiger-Mueller (GM) detectors as well as sodium iodide (NaI) detectors during electrolysis experiments with palladium cathodes in heavy water. These high radiation counts were often observed in codeposition experiments where palladium metal is deposited from a D2O solution onto a copper cathode in the presence of evolving d...

متن کامل

Electrochemical Calorimetric Studies of the Cold Fusion Effect

Several types of calorimetric cell designs were used in attempts to measure excess enthalpy during the electrolysis of LiOD/D2O using palladium cathodes. Control experiments were run by using light water in place of D2O or by using platinum cathodes in place of palladium. Initial experiments using thin palladium cathodes of an unknown purity gave no significant differences between the Pd/D2O ce...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002