The Hydrogen Analysis of Solid Samples
نویسنده
چکیده
Each year the marketplace sees increasing demands for the analysis of hydrogen contained in various sample materials. It is now recognized that hydrogen analysis is crucial not only in the steel industry but also in the manufacture of such high purity metals as aluminum, copper, titanium and in the development of new alloys and new materials. To meet these demands, Horiba has developed and marketed two models of a new type of hydrogen analyzer with a flexible power control function, the EMGA-521 and the EMGA-621. This report discusses the design and principle of measurement of the new hydrogen analyzer, using data from actual measurements. Also introduced here is the behavior of the hydrogen content of the sample when the flexible power control function of the analyzer is used and the importance of sample pre-treatment in hydrogen analysis.
منابع مشابه
Synthesis of WC-8Co cermet powder in WO3-Co3O4-C system by in situ carbothermic solid reduction method under hydrogen atmosphere: (phase, microstructural and thermodynamic analysis)
WC-Co cermets are among the advanced engineering materials that are considered for their special properties such as abrasion resistance and high hardness. The aim of this study was to determine the optimal amount of carbon in raw materials and industrial production of WC-8Co cermet powder from metal oxides WO3, Co3O4 and activated carbon by solid carbothermic reduction method in situ and under ...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملExperimental and Theoretical Study for Hydrogen Biogas Production from Municipal Solid Waste
This study carried out to investigate the production of hydrogen using the organic fraction of municipal solid waste OFMSW, where the anaerobic digester was depended as a method for disposing and treating OFMSW and producing bio-hydrogen. Bio-hydrogen production had been studied under different parameters including pH, solid content T.S%, temperature and mixing ratios between the thick sludge t...
متن کاملExperimental and Theoretical Study for Hydrogen Biogas Production from Municipal Solid Waste
This study carried out to investigate the production of hydrogen using the organic fraction of municipal solid waste OFMSW, where the anaerobic digester was depended as a method for disposing and treating OFMSW and producing bio-hydrogen. Bio-hydrogen production had been studied under different parameters including pH, solid content T.S%, temperature and mixing ratios between the thick sludge t...
متن کاملهیدروژناسیون ترکیب Mg-Ni آسیاب شده
Magnesium hydride is one of the hydrogen storage materials in solid state that is taken into consideration due to its high storage capacity. This paper investigates the adsorption of magnesium and nickel catalyst combination in 473 K at 2.0 and 3.5 Mpa. A planetary ball mill is used in order to produce fine particles and to increase adsorption. A volumetric method (Sievert) is used for hydrogen...
متن کاملHydrogen adsorption by g-C3N4 and graphene oxide nanosheets
The adsorption behavior of hydrogen for synthesized graphitic carbon nitride (g-C3N4) and graphene oxide nanosheets was compared. The structure of the prepared g-C3N4 and graphene oxide samples were studied using TEM, FT-IR spectroscopy and surface area analysis. Textural results of the prepared nanosheets show that the surface area, total pore volume, and average internal diameter of g-C3N4 an...
متن کامل