Readout System for PANDA Silicon Strip Prototyp Studies
نویسندگان
چکیده
The PANDA Experiment at FAIR will include a MicroVertex-Detector (MVD) for tracking and vertexing. The MVD will be composed of silicon pixel detectors and double-sided silicon strip detectors. The strip part will contain approximately 200,000 channels that need to be read out with highly integrated front-ends. A specific feature of the PANDA detector is the data acquisition concept [1]. Contrary to contemporary particle physics experiments there will be no central trigger. Each sub-detector should be able to recognize detector hits individually. Therefore the deployed front-end electronic shall be qualified to distinguish physical events from noise and send this hit information along with a precise time stamp to the event builder.
منابع مشابه
Design of the LHCb Silicon Tracker∗
The LHCb Silicon Tracker is a large-surface silicon micro-strip detector that will cover an important part of the LHCb tracking system. Its data will be used in the trigger to select high-pT daughter particles from B-meson decays, and in the offline analysis to reconstruct trajectories of charged particles in the very forward region of the detector. Readout strips of up to 38 cm in length with ...
متن کاملThe Front-End Driver Card for the CMS Silicon Strip Tracker Readout
The first prototypes of the production version of the Front-End Driver (FED) card for the CMS silicon strip tracker are about to be manufactured. The FEDs provide the off-detector processing of the tracker readout system. They digitise and zero-suppress the multiplexed analogue optical data sent on each Level-1 trigger from the ondetector APV25 pipeline chips. This paper outlines the design and...
متن کاملThe OPAL Silicon Strip Microvertex Detector with Two Coordinate Readout
The OPAL experiment at the CERN LEP collider recently upgraded its silicon strip microvertex detector from one coordinate readout ( only) to two coordinate readout ( and z). This allows three dimensional vertex reconstruction and should improve lifetime measurements as well as b quark jet identi cation. This paper describes the new microvertex detector system with emphasis on the novel techniqu...
متن کاملThe Readout Electronics for Silicon Tracker of the GLAST Beam Test Engineering Model
The design of the Gamma-ray Large Area Space Telescope (GLAST) pairconversion tracker is based upon single-sided silicon-strip detectors with 36 cm long strips. The electronics used to read out this system are based upon CMOS ASICs and are similar in many ways to electronics used in high energy physics experiments. However, stringent requirements on power consumption and reliability, which are ...
متن کاملA control and readout system for the BELLE silicon vertex detector
A newly developed system for the control and readout of the BELLE silicon vertex detector (SVD) is described. The system is designed to meet the mechanical, electrical, and thermal requirements imposed by the BELLE detector. Its primary purpose is the ampli"cation of analog signals from the VA1 front-end integrated circuits, which are used to read the silicon-strip detectors. It also provides a...
متن کامل